Chamberlain Group The 7966 FCC Part 15 Remote Control Transmitter User Manual r1 En

Chamberlain Group Inc, The FCC Part 15 Remote Control Transmitter r1 En

Contents

User Manual_r1_En

3-BUTTON REMOTE CONTROLSMODELS 890MAX, 893MAX, AND 895MAXTo prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote controls.• Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.LEDLEDLocate the Program button on the remote control.Locate the Learn button on the garage door opener.NOTE: Your garage door opener may look different.OR ORLearn LEDLearn LEDLearn LEDGreenorRed/Orange PurpleYellowProgram Button23Press and release the remote control button you want to use...4To exit programming mode, press any remote control button except the button that was just programmed.Install the visor clip (not applicable for Model 890MAX).6The garage door opener will activate.To test, press the programmed button on the remote control...1Press and release the Learn button on the garage door opener.Within 30 seconds...The Learn LED will light.Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to light solid then slowly press and release the remote control button again. Repeat until the light bulb blinks. DO NOT press the button after the light bulb blinks.5To enter programming mode, press the Program button until the LED on the front of the remote control turns on.Safety Pin or Paper ClipVisor ClipMODEL 893MAXMODEL 890MAXPREPAREPROGRAMMING THE REMOTE CONTROL893MAX890MAXMODEL 895MAX895MAXLEDs890MAX895MAX893MAXCan be used as a replacement remote control for 80 Series, 970 Series, and 370 Series LiftMaster remote controls. Compatible with 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993. Make sure the garage door opener has a working light bulb because it is a programming indicator.For use with gate operators, commercial door operators, or other products that are 315 MHz or 390 MHz and have a Learn button. Refer to your product manual for the location of the Learn button.
BATTERYThe LED(s) on your remote control will stop flashing when the battery is low and needs to be replaced. To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery with only 3V2032 or 3V2016 coin cell batteries (depending on the model). Dispose of old battery properly. To prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediately notify doctor.To reduce risk of fire, explosion or chemical burn:• Replace ONLY with 3V2032 coin batteries.• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.1-800-528-9131114A3930B © 2013, The Chamberlain Group, Inc. All Rights Reserved REPLACEMENT PARTS3V2032 Lithium Battery (Models 893MAX & 890MAX) . . . . . . . . . . 10A203V2016 Lithium Battery (Model 895MAX) . . . . . . . . . . . . . . . . . . . . 10A19Visor Clip (Model 893MAX) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29B137Visor Clip (Model 895MAX) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29C151123WARRANTYwww.liftmaster.comONE YEAR LIMITED WARRANTYThe Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is free from defect in materials and/or workmanship for a period of 1 year from the date of purchase.Pry open the case with a screwdriver blade.890MAXPry open the case fi rst in the middle (1), then at each side (2 and 3) with the visor clip.893MAXRemove the two screws and open the case.895MAX3V2032 3V2016Additional buttons on the remote control can be programmed to operate up to 3 devices such as additional garage door openers, light controls, gate operators or access control systems.Press and hold the button down until the door or gate starts to move. The remote control will operate from up to 3 car lengths away on typical installations. Installations and conditions vary, contact an installing dealer for more information.HOW TO USE THE REMOTE CONTROLNOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu