Chaney Instrument 00782TXA1 Wireless Thermometer User Manual
Chaney Instrument Co. Wireless Thermometer
User Manual
Instruction Manual
Specification:
- Indoor and outdoor temperatures displayed on the main LCD readout
- Temperature measurement range:
Indoor main unit: 32F – 122F (0 ºC ~ +50 ºC)
Wireless remote unit: -4 F – 130F (-20 ºC ~ +55 ºC)
- Temperature resolution: 0.1 degree
- Transmission range : up to 100ft. in an open area
Instruction manual:
ATTENTION:
For the fist installation, insert the batteries in the display unit and then in the remote sensor
Battery installation:
Display unit
Insert 2 fresh “AAA” alkaline batteries into the display unit. (Batteries not included)
Remote sensor
Insert 2 fresh “AAA” alkaline batteries into the remote sensor. (Batteries not included)
Getting started:
Indoor Display unit
When the batteries are put into the display unit, it will display the indoor temperature .The outdoor
reading “----”
Remote sensor
When the batteries are placed into the remote sensor, it will signal the temperature to the display unit.
The display unit will then be able to display the outdoor temperature. You may need to push the Reset
button on the back of the display unit.
Reset button
Reset button
Battery Icon Description:
The battery icon will display when the batteries are full.
The battery icon will display and the temperature readings will be blinking when the batteries
are low capacity.
When to replace the Batteries:
For the remote sensor:
When the battery icon of the outdoor window displays continuously the remote sensor batteries
are low and need to be replaced.
Replace the batteries in the Remote sensor and then you MUST press the RESET button on the Indoor
Display unit (receiver).
When the battery icon of the Indoor display unit (receiver) displays please replace the batteries in
the Display unit (receiver).
Antenna Icon Description:
The antenna icon of the indoor window will display waving as when the receiver is receiving RF
signal from the remote sensor.
The antenna icon of the outdoor window will display for 0.5 second when the receiver had
successfully receive the data from the remote sensor.
When the outdoor window displays “- - -”, and the antenna icon of the indoor window displays
continuously, the receiver maybe do not either receive any data from remote sensor or the remote sensor
is located to far away from display unit (out of range). You MUST be press the RESET button on the
Indoor unit (receiver).
Troubleshooting:
Using the Reset button on the Indoor unit (receiver):
In some unusual occasions, the Indoor unit may be affected by electrical interference and respond
abnormally. In such conditions, press the RESET button on the Indoor Display unit to resume
normal operation. “RESETING” The Display unit should give you the indoor immediately and the
outdoor temperature within 1 minute.
Using the Reset button on the remote sensor (sender) In some unusual occasions, the remote sensor
may be affected by electrical interference and respond abnormally. In such conditions, press the
RESET button (located inside the battery compartment) on the remote sensor to resume normal
operation.
If you press the RESET button on the remote sensor, you MUST press the RESET button on the
Indoor Display unit (receiver) as well.
If or when the Indoor unit display “- - -“continuously in the outdoor window, it maybe that the
remote sensor is out of range or the batteries low. Please put the Remote sensor (sender) close to
the Indoor unit (receiver) or replace the fresh batteries.
Note:
If the Remote Sensor “RESET” button is pressed, or new batteries are installed in the Remote
Sensor, you MUST press the Reset button on the Indoor Display unit (receiver).
FCC Statement:
FCCID: RNE000782TXA1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications made to the equipment without the
approval of manufacturer could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Trade Name:
Model Number: 00782
Chaney Instrument Co.
965 S. Wells Street,
Lake Geneva, WI 53147,
Tel: 877-221-1252
LIMITED WARRANTY INTERNATIONAL
Consumer may have more remedies at law than follows. Chaney Instrument Company warrants to the owner, this
product to be free from defect in material and workmanship for one year from date of purchase. CHANEY
INSTRUMENT SHALL NOT BE LIABLE FOR ANY INCIDENTAL, INDIRECT OR CONSEQUENTIAL
DAMAGES, WHETHER ARISING IN CONTRACT OR TORT. Chaney Instrument’s obligation (at its option) is
limited to repair or replace this product. For in- warranty repair, send clock, accompanied by Guarantee, bearing
Dealer’s name and date of purchase, with $5.00 to cover handling and postage, to: Chaney Instrument Company
965 Wells Street Lake Geneva, Wisconsin 53147
Lake Geneva, WISCONSIN 53147 www.chaneyinstrument.com