Chicony Electronics Co MSR0238B Wireless Mouse User Manual User s Guide for Wireless Input Device
Chicony Electronics Co Ltd Wireless Mouse User s Guide for Wireless Input Device
Revised Manual
1
User’s Guide for Wireless Input Device
A. FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, Pursuant to Part 15 the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
! Reorient or relocate the receiving antenna
! Increase the separation between the equipment and receiver
! Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
! Consult the dealer or an experienced radio/TV technician for help
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void your authority to opeate the equipment.
CAUTION: AVOID PROLONGED USE OF THE KEYBOARD WITHOUT
BREAKS. Take regular breaks and keep a good posture. Consult your physician
promptly if you notice any lost of motion or pain in your wrist when using the
keyboard.
WARNING:
2
B. PRODUCT SPECIFICATION
1. Frequency Band: Mouse 27.045 27.095
2. Channel: 2 channels for mouse
3. Frequency Modulation: FSK mode
4. Power Ratting:
Mouse 3V, 50mA (max)
Receiver 5V, 100mA (max)
5. RF Power: <10mW
6. Battery Life Time:
Mouse: 50 working hours with continuous operation
7. Operating Temperature: 0℃ ~ 40℃
Storage Temperature: -10℃ ~ 60℃
C. HARDWARE INSTALLATION
1. Plug the receiver connector into USB port on your computer
2. Load two AA batteries to battery chamber of mouse
D. CHANNEL SETTING WHEN INTERFERENCE OCCURS
1. The first binding by user
Step 1 – Push the button on receiver
Step 2 – Push the button on back of mouse
2. Change channel
Push the button on the back of mouse
Alternate:
Step 1 – Press receiver button, LED green light is blinking
Step 2 – Push mouse button on back of device and then LED light
stops blinking on receiver to confirm channel is changed.
3. Change ID
Step 1 – Press receiver button, LED green light is blinking.
Step 2 – Push the button on the back of mouse more than two seconds
and release, LED green light becomes blinking faster in 3 seconds and
then light is off.
Note: To have maximum performance, avoid placing receiver,
keyboard and mouse on metallic surface. Operating distance
between keyboard, mouse and receiver will depend on the
environment around. User can try various locations for the receiver
in order to find best operating performance.