Chungear Co CE10308 Ceiling Fan Remote Controller (Transmitter) User Manual Manual

Chungear Industrial Co Ltd Ceiling Fan Remote Controller (Transmitter) Manual

Manual

DC POWER CEILING FAN REMOTE CONTROL MANUALLEARNING PROCESSNOTE: The Hand Held Remote Control is equipped with a learning ID function which has codecombinations to prevent potential interference from other remote units.Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning theReceiver AC power ON, press the transmitter buttonStep: 2. Hold button about 5 seconds, once the receiver has detected the ID, the light ofceiling fan will be blinking twice. This will indicate the receiver has learned the ID that waspreviously selected on the transmitter.Note: After the AC power is on, do not press any other buttons on the transmitter before learningok. Because doing so will cause the procedure to fail.After completing the steps above, you should be able to operate the ceiling fan and light. If theceiling fan is not responding to the transmitter, please turn the power off to the receiver andrepeat step 1 and 2.Remove the batteries if not used for long periods of time to prevent damage to the hand heldremote. The batteries must be removed from the transmitter before it is scrapped and the batteries shall bedisposed of safety.Lightfunctionselectswitch:Slide the D/O switch, located in the battery compartment, to match thebulb type in your fan. “D”(DIMMER) for incandescent bulbs and“O”(ON/OFF) indicates compact fluorescent bulbs (CFL). Use a smallscrewdriver or ballpoint pen to slide firmly left or right.FUCNCTIONS OF TRANSMITTER1. ：Turn on/off ceiling fan2. FAN SPEEDPress button to increase speed and LED bar will show at same time. All LED isbrighten for the highest speed. Press button to decrease speed.3..FAN TIMERSetting up that the ceiling fan and light will turn off after2, 4 or 8 hours automatically.4 .:For setting natural wind that the fan speeds turn and change atrandom. It’s three modes for choose.5. : Press this button for forward/reverse airflow of ceiling fan.6．LIGHT :—Press this and release instantly to turn on or off the light.—Press and hold to dim or brighten lights to the desiredlevel and release. (Tungsten bulb only and light O/D switch at Dposition).
To assure continued FCC compliance:FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consultthe dealer or an experienced radio/TV technician for help.CAUTION:To assure continued FCC compliance:Any changes or modifications not expressly approved by the grantee of this device could void the user's authority tooperate the equipment.FCC ID：KUJCE10308This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.

Navigation menu