Chungear Co CE10308 Ceiling Fan Remote Controller (Transmitter) User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	2462565
Application ID	vjYPdNB8JekNHOcBsHXVmA==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	22.22kB (277763 bits)
Date Submitted	2014-12-03 00:00:00
Date Available	2014-12-03 00:00:00
Creation Date	2014-12-01 09:01:43
Producing Software	doPDF Ver 7.3 Build 382 (Windows XP Professional Edition (SP 3) - Version: 5.1.2600 (x86))
Document Lastmod	2014-12-01 11:19:21
Document Title	Manual

DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control is equipped with a learning ID function which has code
combinations to prevent potential interference from other remote units.
Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the
Receiver AC power ON, press the transmitter
button
Step: 2. Hold
button about 5 seconds, once the receiver has detected the ID, the light of
ceiling fan will be blinking twice. This will indicate the receiver has learned the ID that was
previously selected on the transmitter.
Note: After the AC power is on, do not press any other buttons on the transmitter before learning
ok. Because doing so will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and light. If the
ceiling fan is not responding to the transmitter, please turn the power off to the receiver and
repeat step 1 and 2.
Remove the batteries if not used for long periods of time to prevent damage to the hand held
remote. The batteries must be removed from the transmitter before it is scrapped and the batteries shall be
disposed of safety.
Light function select switch:
Slide the D/O switch, located in the battery compartment, to match the
bulb type in your fan. “D”(DIMMER) for incandescent bulbs and
“O”(ON/OFF) indicates compact fluorescent bulbs (CFL). Use a small
screwdriver or ballpoint pen to slide firmly left or right.
FUCNCTIONS OF TRANSMITTER
1.
：Turn on/off ceiling fan
2. FAN SPEED
Press
button to increase speed and LED bar will show at same time. All LED is
brighten for the highest speed. Press
button to decrease speed.
3..FAN TIMER
Setting up that the ceiling fan and light will turn off after
2, 4 or 8 hours automatically.
.: For setting natural wind that the fan speeds turn and change at
random. It’s three modes for choose.
5.
: Press this button for forward/reverse airflow of ceiling fan.
6．LIGHT :
—Press this and release instantly to turn on or off the light.
—Press and hold to dim or brighten lights to the desired
level and release. (Tungsten bulb only and light O/D switch at D
position).
To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult
the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
FCC ID：KUJCE10308
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Page Mode                       : UseNone
XMP Toolkit                     : 3.1-701
Create Date                     : 2014:12:01 09:01:43+08:00
Modify Date                     : 2014:12:01 11:19:21+08:00
Metadata Date                   : 2014:12:01 11:19:21+08:00
Producer                        : doPDF Ver 7.3 Build 382 (Windows XP Professional Edition  (SP 3) - Version: 5.1.2600 (x86))
Format                          : application/pdf
Document ID                     : uuid:a30e37c0-8ec6-4f4d-a94d-21aaeb6a5148
Instance ID                     : uuid:61a3c1ac-096b-451f-9814-4200de7807f1
Page Count                      : 2
Page Layout                     : OneColumn

EXIF Metadata provided by EXIF.tools