Chungear Co CE10507 CEILING FAN REMOTE CONTROLLER (TRANSMITTER) User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3071351
Application ID	b+HLUZIV/yW5v1h0OQzkDQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	25.1kB (313756 bits)
Date Submitted	2016-07-21 00:00:00
Date Available	2016-07-21 00:00:00
Creation Date	2016-07-18 09:55:50
Producing Software	doPDF Ver 7.3 Build 382 (Windows XP Professional Edition (SP 3) - Version: 5.1.2600 (x86))
Document Lastmod	0000-00-00 00:00:00
Document Title	User Manual

DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has
code combinations to prevent potential interference from other remote units.
Step: 1. Install the 1.5V/AAA 2pcs batteries. Within 30 seconds of
turning the Receivers AC power ON. Press the transmitter’s
“LEARN” button.
Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver
has detected the frequency, the receiver will make sound, Bi Bi,
twice. This will indicate the receiver has learned the frequency
that was previously selected on the transmitter.
NOTE: After the AC power is on, do not press any other button on the
transmitter before pressing the “LEARN” button , Because doing so will
cause the procedure to fail.
After completing the steps above, you should be able to operate the
ceiling fan and light. If the fan is not responding to the transmitter,
please turn the power off to the receiver. And repeat step 1 and 2.
NOTE: Remove the battery if not used for long periods of time to prevent
damage to the hand held remote.
LIGHT FUNCTION SELECT SWITCH
If installed energy light onto ceiling fan, please slide the “light function select switch” to “O” position. If installed tungsten
light onto ceiling fan, please slide the “light function select switch” to “D” position.
FUNCTIONS OF TRANSMITTER
1.
FAN SPEED：
1: Turn on ceiling fan at 1st speed (lowest speed)
2. Turn on ceiling fan at 2nd speed
3. Turn on ceiling fan at 3rd speed
4. Turn on ceiling fan at 4th speed
5. Turn on ceiling fan at 5th speed
6. Turn on ceiling fan at 6th speed (high speed)
: Turn off ceiling fan.
2. FAN TIMER: When the fan turned on.
2H ：Setting up that the ceiling fan will turn off after 2 hours automatically.
4H ：Setting up that the ceiling fan will turn off after 4 hours automatically.
8H ：Setting up that the ceiling fan will turn off after 8 hours automatically.
Press
3.
4.
button can cancel fan timer setting.
--“F/R” :Hold this button 2 seconds to set fan wind direction up or down.
-- Natural breeze: Fan speed will modulate to simulate a natural breeze.
Press and turn the light on or off. DIMMER-Press and hold to dim or brighten light
to the desired level and release.
(Tungsten only and light function select switch on “D” position.)
5. Installation of Transmitter Wall Mount Holder with Two screws.
TR249A
To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an
experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate
the equipment.
FCC ID：KUJCE10507
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
Page Layout                     : OneColumn
Page Mode                       : UseNone
Producer                        : doPDF Ver 7.3 Build 382 (Windows XP Professional Edition  (SP 3) - Version: 5.1.2600 (x86))
Create Date                     : 2016:07:18 09:55:50+08:00

EXIF Metadata provided by EXIF.tools