Cobra Electronics 9820WR remote control User Manual x

Cobra Electronics Corporation remote control x

Users Manual

User Manual Remote Control WASPcam 9820WR NOTE**: Before pairing the remote to the camera, format the MicroSD card in the camera. How To Pair the Remote: 1. When the camera is in standby mode, press the menu button twice to enter system settings. 2. Press the left/right arrow buttons to scroll through the menu, choose remote control to enter the remote menu. Then select Remote Match. 3. A message will appear on the LCD Screen “Wait Remote Match”, the camera is now in pairing mode. 4. At the same time, press both buttons on the remote controller to start pairing. Pairing is successful when the LCD screen shows “Remote Match OK” 1 - Indicator light 2 – Photo Button - press to take photos, Press the Inquiry/Record Button (3) and the Photo button (2) simultaneously to enter Pairing mode 3 – Inquiry/Record Button – press to start/stop recording, press and hold for 3 seconds to check the present status of the camera (see below) Remote Control Indicator Light Status Status/LED Red LED Light Blue LED Light Standby 1 time/sec frequently Flickers about 5sec Off Recording Off Light on 3 seconds, then off Status Inquiry Power off Light on 3 secs, then off Off Pairing Long light Long light Success Light on 3 secs, then off Light on 3 secs, then off Pairing Mode Failure Off Off
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Start recording 2 times/sec frequent Flickers about 5sec Off Stop recording 1 time/sec frequent Flickers about 5sec Off Photo Off Flashes once each time you take a photo
IC Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interfe The term “IC: “ before the certification/registration number only signifies that the Industry Canada technical specifications were met. This product meets the applicable Industry Canada technical specifications. Le présent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement

Navigation menu