Coen Consultant VDUL5NA Modular transmitter User Manual DC install guide v1 12
Coencorp Consultant Corporation Modular transmitter DC install guide v1 12
Contents
- 1. Installation Guide
- 2. VDU Manual
Installation Guide
8 Place du Commerce, suite 100, Tel: 1-450-672-4222 Brossard QC Canada J4W 3H2 Toll free (US & Canada): 1-866-COENCORP http://www.coencorp.com Fax: 1-450-672-6038 mailto:info@coencorp.com FleetZone Data Collector Installation Guide Created on: 5/29/2009 9:59 AM Created by: Serge Kopikov Document revision: 1.12 Data Collector Installation Guide revision 1.12 Copyright This document cannot be redistributed to third party, reproduced or modified without written permission from Coencorp. Disclaimer The information in this document is subject to change without notice. While the information contained herein is assumed to be accurate, Coencorp assumes no responsibility for any errors or omissions. Page 2 of 11 Data Collector Installation Guide revision 1.12 Table of contents Introduction ................................................................................................................................................................. 5 Specifications .............................................................................................................................................................. 6 Installing Data Collector.............................................................................................................................................. 7 Connecting Data Collector to a SiteController .......................................................................................................... 10 Page 3 of 11 Data Collector Installation Guide revision 1.12 The North American versions of RF devices included in this manual contain the board having the following agency approval numbers: US/FCC ID VY3-VDUL5NA CAN/IC ID 7522A-VDUL5NA Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Coencorp is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. The devices included in this manual were tested with the following antennae: Device Antenna P/N (Coencorp) FGD-00582-02 (North American ver.) MOD-00797 with RPSMA (internally mounted RF antenna) FGD-00582-03 (European ver.) Warning: Any antenna not explicitly specified in this manual must be tested to comply with FCC section 15.203 for unique antenna connectors and section 15.249 for emissions. Page 4 of 11 Data Collector Installation Guide revision 1.12 Introduction Coencorp RF Data Collector is an RF modem used in Coencorp Fleet and Fuel Management System to collect data from Vehicle Data Units (VDU) and to assist in the automated fueling sequence. The RF communication between Data Collector and VDU uses 915 MHz (North American) or 868 MHz (European) frequency bands. The VDU only sends data in response to requests from Data Collector. The communication has a typical range of 300-600 ft (100-200 m) from the Data Collector. The fixed Data Collector is mounted in a standard sealed electrical enclosure suitable for outdoor use. Besides the standard fixed Data Collector there exists a portable version having the same hardware and software but packaged in a smaller VDU-like enclosure. The portable version of data collector may be used for VDU installation tests with a laptop (see the VDU manual for details). This manual only covers the fixed Data Collector. The Data Collector communicates with host computer through RS-232 serial port or USB (using USB-to-Serial adapter). VDU VDU VDU Site Controller RF Data Collector VDU Figure 1. DataZone Site structure Page 5 of 11 Data Collector Installation Guide revision 1.12 Specifications Parameter FGD-00582-02 (North American version) FGD-00582-03 (European version) Electrical RS-232 baud rate 9600,19200,38400 DC supply voltage 9..25 V DC supply current, max 30 mA RF Radio type Frequency band Channels Channel spacing Range (typical) Antenna connector Antenna Fixed frequency 910.0..920.0 MHz 868 MHz 11 1.0 MHz – 100..200 m (300..600 ft) RP-SMA MOD-00797 Mechanical & Environmental Storage temperature -50..+85 oC Operating temperature -20..+55 oC Dimensions Interface connector 229 mm x 229 mm x 127 mm (9.0” x 9.0” x 5.0”) Screw terminal block Page 6 of 11 Data Collector Installation Guide revision 1.12 Installing Data Collector Mounting plate RF board Terminal block RF antenna A fixed Data Collector connects to a SiteController computer through RS-232 port and does not require special drivers to be installed on the computer. This section contains mechanical sketches and electrical wiring diagrams for the installation. The Data Collector is shipped without cables and connectors: the installer must provide a cable. Figure 3. Data Collector – internal layout Page 7 of 11 Data Collector Installation Guide 11.5" (292 mm) 10.5" (267 mm) 9.0" (229 mm) revision 1.12 9.0" (229 mm) 10.5" (267 mm) 5.0" (127 mm) 11.5" (292 mm) Figure 2. Data Collector – outside dimensions Page 8 of 11 Data Collector Installation Guide revision 1.12 Figure 4. Data Collector mounted on a wall (cover removed) +12V RET COM TX RX Figure 5. Data Collector – terminal block Page 9 of 11 Data Collector Installation Guide revision 1.12 Wall plug power supply 9-12 VDC, 0.5A +Vout -Vout COM1 SiteController DB9-F 100' (30 m) max RX TX COM RET 12V Connecting Data Collector to a SiteController RF Data Collector Figure 6. Data Collector connection to a SiteController through RS-232 Page 10 of 11 COM COM +12V COM COM +12V +Vout DB9-M -Vout RD(A) RD(B) 4WSD9OTB TD(A) TD(B) RD(A) RD(B) 4WSD9OTB TD(A) TD(B) 1000' (300 m) max Wall plug power supply 9-12 VDC, 0.5A COM1 SiteController RET 12V TX COM RX RF Data Collector Data Collector Installation Guide revision 1.12 Figure 7. Data Collector connection to a SiteController through RS-422 (extended cable run). Page 11 of 11
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 11 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:e553df55-ce55-42c3-bf9b-4d8f1592c4f3 Producer : Acrobat Distiller 6.0 (Windows) Create Date : 2009:05:29 10:00:11-07:00 Creator Tool : PScript5.dll Version 5.2 Modify Date : 2009:05:29 10:00:11-07:00 Document ID : uuid:f97fdda8-e23a-489b-8093-ca60a75f6f87 Format : application/pdf Title : Microsoft Word - DC install guide v1.12.doc Creator : sandyv Author : sandyvEXIF Metadata provided by EXIF.tools