Coleman 9260 703 9260N707 Sundome 7x7 Tent User Manual To The 2124a79f 1206 48ed Be64 5fcf5f8562f7

User Manual: Coleman 9260-703 to the manual

Open the PDF directly: View PDF .
Page Count: 2

Download
Open PDF In Browser	View PDF

SUNDOME ™ 7’x 7’
Instructions apply to Part Number 9260N707
When You Are Ready To Set Up
Your Tent

POLE ASSEMBLY PARTS

Main Tent
–Select a level campsite clear of rocks,
Poles
branches and other hard or sharp objects.
–Do not set up your tent under trees. ™
–For best results in windy conditions,
Rainfly Pole
position the end of tent into the wind.
–See owners manual for more tips.
Rainfly

1

Layout & Positioning
of Tent, Pole
Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door
–Stake down tent corners only, using the
rings at the end of the stake loops.
Keep the floor taut.
–Assemble Frame Poles by
interlocking shock-corded poles.
This will make two long poles.
–Insert the poles diagonally into Pole
Sleeves.The center of the poles should
cross forming an “X” in the middle of
tent. (illus. 1)
–Fasten Frame Tie on top of tent over
both poles. (illus. 1), (illus. 3)

Assembled
poles
inserted
through
pole
sleeves

Part No. 9260A702

Part No. 9260-703

Part No. 9260M704

2

Connect Frame to Tent
–Insert one end of main tent pole end
onto pin of ring and pin system, at tent
corner. (illus. 4)
–Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole
–Repeat for second pole
illus. 3
Frame Tie

illus. 5
Frame Tie

Tent frame
set-up

illus.4
Insert pole end onto
pin & ring

illus. 1
illus. 2 Tent stake
through ring

3

Attach Tent to Frame
Using Frame Clips
–Attach Frame Clips along
the edges of tent to frame poles
(illus. 5), (illus. 6)
–Make any adjustments to the tent
corner stakes that are needed.

illus. 5
Frame Clips

illus. 6
Assembled tent without
Rainfly. Note the Frame Clips
located on edge of tent.

4

Rainfly Pocket

Attach Rainfly
–Assemble Rainfly Pole by
interlocking shock-corded pole
–Insert Rainfly Pole into reinforced
Frame
pockets located at the center edges
Ties
illus.
7
Insert Rainfly
of the underside of Rainfly
Pole piece into
(illus. 7), (illus. 8)
pocket on underside
–Tie underside of Rainfly to the Rainfly of Rainfly
Pole with Frame Ties (illus. 8)
–Drape Rainfly over tent frame, pole
side down. Rainfly Pole should
point out over door and rear window.
–Connect the four elastic loops with
“S” hooks, (found at the Rainfly
corners) to the four rings
located at the end of the Stake
Side
Loops at the corners of the tent.
Guyline
–Secure Rainfly with Frame Ties
illus. 9 Completed tent with Rainfly.
located on underside of fly (illus. 9)
Note where Rainfly Pole pockets ,
–Stake out the tent with 2 side
rings, and under ties are located.
guylines (illus. 9)

Things You Should Know

• Under certain conditions (cold weather, high

humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent.
Use separate storage bag.

illus. 8
Rainfly
pockets
Underside of
Rainfly
attaches to
frame poles

“S” Hooks attach
Rings at the corners

•

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material
and/or cause it to become discolored.
See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84. The fabric may burn left in continuous contact
with any flame source. The application of any foreign substance to the
tent fabric may render the flame-resistant properties ineffective.

•

•

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.

•
•

Seam sealer has not been provided with your tent. It is necessary
and we recommend seam sealing your tent prior to camping. Seam sealer
may be purchased through your local retailer or at your local sporting goods
store.

PRINTED IN CHINA

Rev. 6/01

THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com

MADE IN KOREA, ASSEMBLED IN CHINA



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2001:08:10 12:03:32Z
Subject                         : 9260N707 Sundome 7x7 Tent
Keywords                        : Manuals
Modify Date                     : 2005:03:07 13:33:39-06:00
Page Count                      : 2
Creation Date                   : 2001:08:10 12:03:32Z
Producer                        : Acrobat Distiller 3.01 for Windows
Author                          : 9260N707 Sundome 7x7 Tent
Mod Date                        : 2005:03:07 13:33:39-06:00
Metadata Date                   : 2005:03:07 13:33:39-06:00
Creator                         : 9260N707 Sundome 7x7 Tent
Title                           : 9260N707 Sundome 7x7 Tent
Description                     : 9260N707 Sundome 7x7 Tent

EXIF Metadata provided by EXIF.tools