Coleman 9271L133 Ridgeview Instr User Manual To The 6c24285e Bc0f 4ae5 B4cf 80b12f9d061c
User Manual: Coleman 9271L133 to the manual
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
13’x13’ Ridgeview Instructions apply to Part Number 9271L133 When You Are Ready To Set Up Your Tent – Select a level campsite clear of rocks, branches and other hard or sharp objects. – Do not set up your tent under trees. – For best results in windy conditions, position the end of tent into the wind. POLE ASSEMBLY PARTS (2) Center Tent Poles (2) Side Tent Poles Part No. 9270L102 Part No. 9271L105 Part No. 9270L103 (2) Rainfly Poles Rainfly Part No. 9271L104 1 Layout & Positioning of Tent, Pole Assembly illus. 1 Side pole – Layout and position tent with doors facing desired direction. (illus. 1) – Stake down tent corners, using the tent stake loops. Keep the floor taut. (illus. 2) – Assemble all poles by interlocking Door shock-corded poles. – Insert the longer Center Frame Poles into Center Pole Sleeves. The poles should cross forming an “X” in the middle of tent. (illus. 1) – Insert the shorter Side Frame Poles through the pole sleeves located at the sides of tent. (illus. 1) 2 Center poles Side pole Door illus. 2 Tent stake through stake loop Connect Frame to Tent – Unzip doors. – Locate the Pin & Ring Systems on either side of the front doors and the corresponding Pin & Ring on the back side of tent. – Insert one end of Frame Pole onto Pin & Ring System on tent stake loop on either side of the doors. (illus. 3) – Go to opposite end of pole diagonally from starting point and gradually apply pressure to the pole forming an arch until you are able to insert the Pin into pole end. – Repeat for second pole. – Attach tent frame clips to poles. Center poles Sidepole Sidepole illus. 4 Center section upright illus. 3 Ring & Pin System 3 Raise Ends of Tent Grommets for rainfly poles illus. 5 Frame Clips – Insert one end of the Side Frame Pole onto the Pin & Ring System. Side pole – Repeat for other Side pole. – Go to opposite end of pole and gradually apply pressure until pole arches enough to fit onto Pin. – Attach Frame clips. Side pole illus. 6 Assembled tent without Rainfly. Note the Frame Clips located on tent. 4 Attach Rainfly illus. 7 Insert rainfly pole through pole sleeve on underside of rainfly. – Assemble rainfly poles by interlocking shock-corded poles. – Insert rainfly poles into pole 4 Main guylines attach to sleeves located at the center fabric loops on rainfly. edges of the underside of rainfly. (illus. 7), (illus. 8) – Drape rainfly over tent, pole side Frame ties located on down. The rainfly poles should under side of rainfly. be over the doors of the tent. – Insert the ends of the rainfly poles End guylines into the grommets on the tent body. – Secure the underside of the rainfly to the tent poles. – Connect the elastic loops with “S” hooks (found at the rainfly corners) to fabric loops End near frame clips. guylines illus. 8 – Attach guylines to fabric loops on Completed tent with rainfly. Note the 2 guy rainfly. Two at each end over side lines on each end and 4 main guylines. windows and four on the rainfly. Stake out guylines away from the illus. 9 tent at an angle. (illus. 9) Stake out tent with adjustable guylines. Slide the disc up the rope to tighten guyline. Things You Should Know • Under certain conditions (cold weather, high humidity, etc.) • Do not leave your tent set-up for weeks at a time, be aware that • Never store tent, even for a short period of time, without drying it WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective. condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent. thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag. exposure to the ultraviolet rays of the sun can seriously damage nylon material and/or cause it to become discolored. • STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE. TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE. • • Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store. PRINTED IN CHINA Rev. 7/04 THE COLEMAN CO., INC. 3600 N. Hydraulic • Wichita, Kansas 67219 1-800-835-3278 • www.coleman.com MADE IN CHINA
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Create Date : 2005:01:18 16:42:39Z Modify Date : 2005:03:07 14:05:10-06:00 Creator : QuarkXPress(R) 4.1 Keywords : Manuals Subject : 9271L133 Ridgeview 13' x 13' Tent Page Count : 2 Creation Date : 2005:01:18 16:42:39Z Mod Date : 2005:03:07 14:05:10-06:00 Producer : Acrobat Distiller 5.0.5 for Macintosh Author : 9271L133 Ridgeview 13' x 13' Tent Metadata Date : 2005:03:07 14:05:10-06:00 Title : 9271L133 Ridgeview instr (Page 1)EXIF Metadata provided by EXIF.tools