Coleman 9271L133 Ridgeview Instr User Manual To The 6c24285e Bc0f 4ae5 B4cf 80b12f9d061c

User Manual: Coleman 9271L133 to the manual

Open the PDF directly: View PDF .
Page Count: 2

Layout & Positioning

of Tent, Pole Assembly

– Layout and position tent with doors

facing desired direction. (illus. 1)

– Stake down tent corners,

using the tent stake loops.

Keep the floor taut. (illus. 2)

– Assemble all poles by interlocking

shock-corded poles.

– Insert the longer Center Frame Poles into

Center Pole Sleeves. The poles should cross

forming an “X” in the middle of tent. (illus. 1)

– Insert the shorter Side Frame Poles through the pole

sleeves located at the sides of tent. (illus. 1)

Connect Frame to Tent

– Unzip doors.

– Locate the Pin & Ring Systems on

either side of the front doors and the

corresponding Pin & Ring on the

back side of tent.

– Insert one end of Frame Pole onto

Pin & Ring System on tent stake loop

on either side of the doors. (illus. 3)

– Go to opposite end of pole diagonally

from starting point and gradually

apply pressure to the pole forming

an arch until you are able to insert

the Pin into pole end.

– Repeat for second pole.

– Attach tent frame clips to poles.

13’x13’ Ridgeview

1

2

When You Are Ready

To Set Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard or

sharp objects.

– Do not set up your tent under trees.

–For best results in windy conditions,

position the end of tent into the wind.

(2) Side Tent

Poles

(2) Rainfly Poles

Rainfly Part No. 9271L104

(2) Center Tent

Poles

Door

Door

Instructions apply to Part Number 9271L133

illus. 1

illus. 2 Tent

stake through

stake loop

illus. 4

Center section upright

Part No. 9270L102

Part No. 9271L105

Part No. 9270L103

illus. 3

Ring & Pin System

Center poles

Side pole

Side pole

Center poles

Sidepole

Sidepole

POLE ASSEMBLY PARTS

3Raise Ends of Tent

– Insert one end of the Side Frame Pole

onto the Pin & Ring System.

– Repeat for other Side pole.

– Go to opposite end of pole and

gradually apply pressure until pole

arches enough to fit onto Pin.

– Attach Frame clips.

4Attach Rainfly

– Assemble rainfly poles by

interlocking shock-corded poles.

– Insert rainfly poles into pole

sleeves located at the center

edges of the underside of rainfly.

(illus. 7), (illus. 8)

– Drape rainfly over tent, pole side

down. The rainfly poles should

be over the doors of the tent.

– Insert the ends of the rainfly poles

into the grommets on the tent body.

– Secure the underside of the rainfly

to the tent poles.

– Connect the elastic loops

with “S” hooks (found at the

rainfly corners) to fabric loops

near frame clips.

– Attach guylines to fabric loops on

rainfly. Two at each end over side

windows and four on the rainfly.

Stake out guylines away from the

tent at an angle. (illus. 9)

illus. 6

Assembled tent without Rainfly. Note

the Frame Clips located on tent.

illus. 5

Frame Clips

illus. 8

Completed tent with rainfly. Note the 2 guy

lines on each end and 4 main guylines.

Side pole

Side pole

End

guylines

End guylines

4 Main guylines attach to

fabric loops on rainfly.

Frame ties located on

under side of rainfly.

illus. 9

Stake out tent with adjustable guylines. Slide

the disc up the rope to tighten guyline.

illus. 7 Insert rainfly pole through

pole sleeve on underside of rainfly.

PRINTED IN CHINA Rev. 7/04

Things You Should Know

• Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside surfaces of your tent. Condensation is

caused by water vapor from your breath, perspiration, or any wet clothing

inside your tent. It is NOT LEAKAGE through the tent fabric. It can be

minimized by removing wet clothing from your tent and by providing good

ventilation through the tent.

• Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside

your tent. Use separate storage bag.

• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO

REMOVE STAKE.

• TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

• Seam sealer has not been provided with your tent. For additional protection

we recommend seam sealing your tent prior to camping. Seam sealer may be

purchased through your local retailer or at your local sporting goods store.

• Do not leave your tent set-up for weeks at a time, be aware that

exposure to the ultraviolet rays of the sun can seriously damage nylon

material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability

requirements of CPAI-84.The fabric will burn if left in continuous

contact with any flame source.The application of any foreign substance

to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA

Grommets for rainfly poles