Conair Facial Steamer Users Manual

Facial Steamer to the manual 6adb60a6-32d3-4599-9fd6-09549435409f

: Conair Conair-Facial-Steamer-Users-Manual-471773 conair-facial-steamer-users-manual-471773 conair pdf

Open the PDF directly: View PDF .
Page Count: 2

Download
Open PDF In Browser	View PDF

03PC2407 MDF2 IB

8/19/03 10:05 AM Page 1

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be followed,
including the following:

READ ALL
INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER

DANGER –
To reduce the risk of electrocution:
1. Always unplug this appliance immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or
other liquid.
5. Do not reach for an appliance that has
fallen into water or other liquid. Unplug
immediately.

WARNING –To reduce the

risk of burns, electrocution, fire, or injury to
persons:
1. An appliance should never be left unattended
when plugged in.
2. This product is not to be used by, on, or

near children or by individuals with certain
disabilities.
3. Use this appliance only for its intended
purpose as described in the manual. Do
not use attachments not recommended by
the manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged,
or dropped into water. Return the appliance to
a service center for examination and repair.
5. Keep the cord away from heated surfaces.
Do not wrap the cord around the appliance.
6. To avoid burning, do not pick up the unit
while water is hot since water can spill out.
7. Never block the air openings of the
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
may be blocked. Keep the air openings free
of lint, hair, and other debris.
8. Never use while sleeping.
9. Never drop or insert any object into any
opening or hose.
10. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
11. Do not use an extension cord with
this appliance.
12. Unplug this appliance before filling. Fill
reservoir with tap water only. Do not overfill.
13. Use The Microdermabrasion Facial Spa
only on a level surface.
14. Do not use additives.
15. Never place face close to facial steamer
in one position as this may cause scalding.
16. To avoid burning, do not touch after
plugging in water reservoir unit.

17. Do not mix old and new batteries. Do
not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel cadmium) batteries.
18. Do not use the spa without the mask.
19. Do not place hand in the base.
20. Do not touch steam as it comes out of
the base.
21. Do not move or pick up the unit until the
water cools.

This product should not be used in the
following cases:
Tuberculosis, benign and malignant tumors,
inflammations of the skin, phlebitis and
thrombosis, open and fresh wounds, bruises,
broken skin or varicose veins.

SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS

Before beginning, cleanse your face, following
your daily care routine. Lightly pat your
favorite moisturizer or eye cream around the
eye area.

This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse plug. If it still does not fit,
contact a qualified electrician. Do not attempt
to defeat this safety feature.
• The Microdermabrasion unit operates on 2
“AA” batteries. For battery
insertion, gently pull down
lower cap and insert
batteries.
If you have any skin
condition, sensitivity to
heat, or other health issues
or questions, including those relating to use
of this product while undergoing any
treatments or taking any medications, please
consult with a physician before use.

INSTRUCTIONS FOR USING
YOUR MICRODERMABRASION
SPA

USING YOUR FACIAL
STEAMING UNIT
• Your Facial Spa includes two detachable
cones:
1. Facial Mask: Use for facial cleaning.
2. Sinus Cone: Use for concentrated
steam to assist in respiratory therapy.
Place your nose in the sinus cone with
forehead touching curved rim. Relax as
soothing mist promotes easier breathing,
however, do not use as room humidifier.
• Turn facial mask or sinus cone counterclockwise and lift away
from base.
• Fill the water cylinder
with warm tap water. Pour
water into the reservoir
and plug it into a 120 volt
AC household outlet. (See
Figure 1
Figure 1)

• Place facial mask or
sinus cone over unit. Lock
by aligning bumps on
facial mask with slots
over water reservoir and
turn clockwise. (See
Figure 2)
Figure 2
• Press “ON/OFF” button to turn unit on.
• When the power is on, the ready indicator
light will flash for 3 minutes as the water is
preheating.
• When the indicator light has stopped
flashing and is steady, you may use the
Facial Spa. Unit will automatically shut off
after 45 minutes.
• FOR A TIMED TREATMENT, the timer
control can be set from 3 to 15 minutes by
rotating the knob to desired time.
• Press the timer start button and the timer
indicator light will go on.
• The unit will shut off and a buzzer will
sound to indicate that preset time has expired.
NOTE: One fill provides between 10-30
minutes of soothing mist. If the facial spa
should run out of water, shut off
immediately, then begin your facial again.
• Clean your face and neck
• Allow approximately 3 to 4 minutes for
steam mist to develop, then place your face
gently against the rim of the facial mask or
sinus cone. To avoid burning, do not pick
up the unit while water is hot since water
will spill out.
• If more steam is desired, place a towel
over your head that so it covers the mask
and sides of the steamer.
• Close your eyes and relax as the soothing

mist begins deep cleansing action.
• Remove your face occasionally and blot
with a cool, damp towel. Steam for a
minimum of 5 minutes, but no longer than
30 minutes.
• Immediately after steaming, rinse your
face with cool water.

INSTRUCTIONS FOR USING
YOUR MICRODERMABRASION
TOOL
• Snap the exfoliating brush attachment
onto the unit, making sure it is securely
attached.
• Apply a generous amount of your favorite
exfoliating cream to your face.
• At the speed of your choice, massage the
cleanser on your face in a circular motion,
making sure not to exceed two minutes.
• Use for 10 second intervals per area
beginning with the forehead; avoiding the
eye area, move downwards toward the
cheek and nose area then to your chin area.
This step exfoliates, thoroughly cleans and
removes dulled skin cells. Rinse face and
pat dry. Next apply cool water or your
favorite astringent to close pores and seal
in moisture.
• Now you are ready to apply your favorite
moisturizing lotion by using the sponge
applicator. Dot your forehead, cheeks, nose
and chin with a generous amount of moisturizer and smooth the cream into your
skin. Apply light to medium pressure and
use upward, circular strokes. After just one
personal facial with the Microdermabrasion
Facial Spa you’ll find your skin looking
fresher and healthier.

03PC2407 MDF2 IB

8/19/03 10:05 AM Page 2

SPECIAL PAMPERING TIPS
FOR DELICATE AREAS
THE EYE AREA
• Give special care to the eye area during your
personal facial, by lightly massaging additional
moisturizer or eye cream on eyelids and under
your eyes before you begin.
THE NECK & THROAT
• Apply your favorite moisturizer to your
entire face.
• Mist your face for only 5 minutes, following
Instructions For “Your Personal Facial”.
• Tilt your head backward so your throat is
approximately 2 inches from the facial mask.
• Mist your throat for 2 minutes. For best
results, accelerate moisturizing process by
gently turning neck from side to side.
SPECIAL USES
• Consult your physician or dermatologist
for instructions on how to best use The
Microdermabrasion Facial Spa for your
specific condition.

USER MAINTENANCE
INSTRUCTIONS
Caring for The Microdermabrasion Facial Spa
After Completing Your Facial:
• Always turn off and unplug The
Microdermabrasion Facial Spa from the
electrical outlet before cleaning.
• Let cool then empty excess water, and wipe
dry interior of the facial mask and rim
around the opening.
• Wipe the base with a clean, damp cloth,
then polish lightly with a dry one. NEVER
IMMERSE THE FACIAL SAUNA IN WATER.
• Do not attempt to repair the appliance

yourself. Return to the place of purchase
with sales receipt.
• Facial sponge and brush attachments
should be cleaned after each use by running
them under warm water. Rinse thoroughly
and squeeze out any excess water. Allow
attachments to air dry thoroughly before
reusing. Clean the Microdermabrasion unit
with a dry cloth only. Do not immerse in
water.

CAUTION
Never allow the power supply cord to
be pulled, twisted or severely bent. Never
wrap the cord tightly around the unit.
Damage will occur at the high flex point of
entry into the unit, causing it to rupture and
short circuit. Inspect the cord frequently
for damage. Stop use immediately if
damage is visible or unit stops or operates
intermittently.
If cord or unit is damaged or does not
operate properly, return it for repair to an
authorized Conair Service representative
only. No repairs should be attempted by
the consumer.
The Microdermabrasion Facial Spa is for
household use only.

STORAGE-Important
When not in use, your unit should be
disconnected and stored in a safe, dry
location, out of reach of children. Do not
wrap line cord around unit. Allow the cord to
hang or lie loose and straight at the point of
entry into the unit.

LIMITED ONE YEAR WARRANTY
Conair will repair or replace (at our option)
your unit free of charge for 12 months from
the date of purchase if the appliance is
defective in workmanship or materials.
To obtain service under this warranty, return
the defective product to the service center
listed below that is nearest you, together with
your purchase receipt and $3.00 for postage
and handling. California residents need only
provide proof of purchase and should call
1-800-366-0937 for shipping instructions.
In the absence of a purchase receipt, the
warranty period shall be 12 months from the
date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED
IN DURATION TO THE 12 MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how
long an implied warranty lasts, so the above
limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH
OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some
states do not allow the exclusion or limitation
of special, incidental, or consequential damages, so the above limitation may not apply to
you.
This warranty gives you specific legal rights,
and you may also have other rights, which
vary from state to state.

WARNING:
IF YOU THINK THE
POWER IS OFF
WHEN THE SWITCH
IS OFF,
YOU’RE WRONG.
KEEP AWAY FROM WATER

SERVICE CENTERS:
CONAIR CORPORATION
Service Department150 Milford Road
East Windsor, NJ 08520

MOISTURIZING MIST

MICRODERMABRASION
SYSTEM

CONAIR CORPORATION
Service Department
Glendale, AZ 85307
7475 North Glen Harbor Blvd.
Visit us on the web at: www.conair.com
©2003 CONAIR CORPORATION
East Windsor, NJ 08520
Glendale, AZ 85307
Replacement Parts
RP-FBS

Everyone knows that electricity and water
are a dangerous combination. But did
you know that an electrical appliance is
still electrically alive even if the switch is
off? If the plug is in, the power is on. So
when you are not using your appliances,
keep them unplugged.

Instruction Booklet
Model MDF2

ALWAYS UNPLUG SMALL
APPLIANCES
Public Service Ad from Association of Home
Appliance Manufacturers and Underwriters
Laboratories, Inc.

®

Model MDF2
03PC2407

IB-4879



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:08:23
Create Date                     : 2003:08:19 10:05:47Z
Modify Date                     : 2008:08:26 08:20:44-04:00
Metadata Date                   : 2008:08:26 08:20:44-04:00
Producer                        : Acrobat Distiller 4.0 for Macintosh
Format                          : application/pdf
Document ID                     : uuid:a6684b7c-e98b-2a4a-8166-2e12afc50b11
Instance ID                     : uuid:e80460dc-31ec-3945-b2e4-285a150c651f
Page Count                      : 2

EXIF Metadata provided by EXIF.tools