Conair Facial Steamer Users Manual

Facial Steamer to the manual 6adb60a6-32d3-4599-9fd6-09549435409f

: Conair Conair-Facial-Steamer-Users-Manual-471773 conair-facial-steamer-users-manual-471773 conair pdf

Open the PDF directly: View PDF .
Page Count: 2

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, especially

when children are present, basic safety

precautions should always be followed,

including the following:

READ ALL

INSTRUCTIONS

BEFORE USING

KEEP AWAY FROM WATER

DANGER –

To reduce the risk of electrocution:

1. Always unplug this appliance immediately

after using.

2. Do not use while bathing.

3. Do not place or store appliance where it

can fall or be pulled into a tub or sink.

4. Do not place in or drop into water or

other liquid.

5. Do not reach for an appliance that has

fallen into water or other liquid. Unplug

immediately.

WARNING –To reduce the

risk of burns, electrocution, fire, or injury to

persons:

1. An appliance should never be left unattended

when plugged in.

2. This product is not to be used by, on, or

near children or by individuals with certain

disabilities.

3. Use this appliance only for its intended

purpose as described in the manual. Do

not use attachments not recommended by

the manufacturer.

4. Never operate this appliance if it has a

damaged cord or plug, if it is not working

properly, or if it has been dropped, damaged,

or dropped into water. Return the appliance to

a service center for examination and repair.

5. Keep the cord away from heated surfaces.

Do not wrap the cord around the appliance.

6. To avoid burning, do not pick up the unit

while water is hot since water can spill out.

7. Never block the air openings of the

appliance or place it on a soft surface, such

as a bed or couch, where the air openings

may be blocked. Keep the air openings free

of lint, hair, and other debris.

8. Never use while sleeping.

9. Never drop or insert any object into any

opening or hose.

10. Do not use outdoors or operate where

aerosol (spray) products are being used or

where oxygen is being administered.

11. Do not use an extension cord with

this appliance.

12. Unplug this appliance before filling. Fill

reservoir with tap water only. Do not overfill.

13. Use The Microdermabrasion Facial Spa

only on a level surface.

14. Do not use additives.

15. Never place face close to facial steamer

in one position as this may cause scalding.

16. To avoid burning, do not touch after

plugging in water reservoir unit.

17. Do not mix old and new batteries. Do

not mix alkaline, standard (carbon-zinc), or

rechargeable (nickel cadmium) batteries.

18. Do not use the spa without the mask.

19. Do not place hand in the base.

20. Do not touch steam as it comes out of

the base.

21. Do not move or pick up the unit until the

water cools.

SAVE THESE

INSTRUCTIONS

OPERATING

INSTRUCTIONS

This appliance has a polarized plug (one

blade is wider than the other). As a safety

feature, this plug will fit in a polarized outlet

only one way. If the plug does not fit fully in

the outlet, reverse plug. If it still does not fit,

contact a qualified electrician. Do not attempt

to defeat this safety feature.

• The Microdermabrasion unit operates on 2

“AA” batteries. For battery

insertion, gently pull down

lower cap and insert

batteries.

If you have any skin

condition, sensitivity to

heat, or other health issues

or questions, including those relating to use

of this product while undergoing any

treatments or taking any medications, please

consult with a physician before use.

mist begins deep cleansing action.

• Remove your face occasionally and blot

with a cool, damp towel. Steam for a

minimum of 5 minutes, but no longer than

30 minutes.

• Immediately after steaming, rinse your

face with cool water.

INSTRUCTIONS FOR USING

YOUR MICRODERMABRASION

TOOL

• Snap the exfoliating brush attachment

onto the unit, making sure it is securely

attached.

• Apply a generous amount of your favorite

exfoliating cream to your face.

• At the speed of your choice, massage the

cleanser on your face in a circular motion,

making sure not to exceed two minutes.

• Use for 10 second intervals per area

beginning with the forehead; avoiding the

eye area, move downwards toward the

cheek and nose area then to your chin area.

This step exfoliates, thoroughly cleans and

removes dulled skin cells. Rinse face and

pat dry. Next apply cool water or your

favorite astringent to close pores and seal

in moisture.

• Now you are ready to apply your favorite

moisturizing lotion by using the sponge

applicator. Dot your forehead, cheeks, nose

and chin with a generous amount of mois-

turizer and smooth the cream into your

skin. Apply light to medium pressure and

use upward, circular strokes. After just one

personal facial with the Microdermabrasion

Facial Spa you’ll find your skin looking

fresher and healthier.

This product should not be used in the

following cases:

Tuberculosis, benign and malignant tumors,

inflammations of the skin, phlebitis and

thrombosis, open and fresh wounds, bruises,

broken skin or varicose veins.

INSTRUCTIONS FOR USING

YOUR MICRODERMABRASION

SPA

Before beginning, cleanse your face, following

your daily care routine. Lightly pat your

favorite moisturizer or eye cream around the

eye area.

USING YOUR FACIAL

STEAMING UNIT

• Your Facial Spa includes two detachable

cones:

1. Facial Mask: Use for facial cleaning.

2. Sinus Cone: Use for concentrated

steam to assist in respiratory therapy.

Place your nose in the sinus cone with

forehead touching curved rim. Relax as

soothing mist promotes easier breathing,

however, do not use as room humidifier.

• Turn facial mask or sinus cone counter-

clockwise and lift away

from base.

• Fill the water cylinder

with warm tap water. Pour

water into the reservoir

and plug it into a 120 volt

AC household outlet. (See

Figure 1) Figure 1

• Place facial mask or

sinus cone over unit. Lock

by aligning bumps on

facial mask with slots

over water reservoir and

turn clockwise. (See

Figure 2)

• Press “ON/OFF” button to turn unit on.

• When the power is on, the ready indicator

light will flash for 3 minutes as the water is

preheating.

• When the indicator light has stopped

flashing and is steady, you may use the

Facial Spa. Unit will automatically shut off

after 45 minutes.

• FOR A TIMED TREATMENT, the timer

control can be set from 3 to 15 minutes by

rotating the knob to desired time.

• Press the timer start button and the timer

indicator light will go on.

• The unit will shut off and a buzzer will

sound to indicate that preset time has expired.

NOTE: One fill provides between 10-30

minutes of soothing mist. If the facial spa

should run out of water, shut off

immediately, then begin your facial again.

• Clean your face and neck

• Allow approximately 3 to 4 minutes for

steam mist to develop, then place your face

gently against the rim of the facial mask or

sinus cone. To avoid burning, do not pick

up the unit while water is hot since water

will spill out.

• If more steam is desired, place a towel

over your head that so it covers the mask

and sides of the steamer.

• Close your eyes and relax as the soothing

Figure 2

03PC2407 MDF2 IB 8/19/03 10:05 AM Page 1

LIMITED ONE YEAR WARRANTY

Conair will repair or replace (at our option)

your unit free of charge for 12 months from

the date of purchase if the appliance is

defective in workmanship or materials.

To obtain service under this warranty, return

the defective product to the service center

listed below that is nearest you, together with

your purchase receipt and $3.00 for postage

and handling. California residents need only

provide proof of purchase and should call

1-800-366-0937 for shipping instructions.

In the absence of a purchase receipt, the

warranty period shall be 12 months from the

date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS,

OR LIABILITIES, INCLUDING BUT NOT

LIMITED TO THE IMPLIED WARRANTY OF

MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE, SHALL BE LIMITED

IN DURATION TO THE 12 MONTH DURATION

OF THIS WRITTEN, LIMITED WARRANTY.

Some states do not allow limitations on how

long an implied warranty lasts, so the above

limitations may not apply to you.

IN NO EVENT SHALL CONAIR BE LIABLE FOR

ANY SPECIAL, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES FOR BREACH

OF THIS OR ANY OTHER WARRANTY,

EXPRESS OR IMPLIED, WHATSOEVER. Some

states do not allow the exclusion or limitation

of special, incidental, or consequential dam-

ages, so the above limitation may not apply to

you.

This warranty gives you specific legal rights,

and you may also have other rights, which

vary from state to state.

WARNING:

IF YOU THINK THE

POWER IS OFF

WHEN THE SWITCH

IS OFF,

YOU’RE WRONG.

KEEP AWAY FROM WATER

Everyone knows that electricity and water

are a dangerous combination. But did

you know that an electrical appliance is

still electrically alive even if the switch is

off? If the plug is in, the power is on. So

when you are not using your appliances,

keep them unplugged.

ALWAYS UNPLUG SMALL

APPLIANCES

Public Service Ad from Association of Home

Appliance Manufacturers and Underwriters

Laboratories, Inc.

SERVICE CENTERS:

CONAIR CORPORATION

Service Department150 Milford Road

East Windsor, NJ 08520

CONAIR CORPORATION

Service Department

Glendale, AZ 85307

7475 North Glen Harbor Blvd.

Visit us on the web at: www.conair.com

©2003 CONAIR CORPORATION

East Windsor, NJ 08520

Glendale, AZ 85307

Replacement Parts

RP-FBS

®

Model MDF2

Instruction Booklet

MICRO

MOISTURIZING MIST

DERMABRASION

SYSTEM

Model MDF2 IB-4879

03PC2407

yourself. Return to the place of purchase

with sales receipt.

• Facial sponge and brush attachments

should be cleaned after each use by running

them under warm water. Rinse thoroughly

and squeeze out any excess water. Allow

attachments to air dry thoroughly before

reusing. Clean the Microdermabrasion unit

with a dry cloth only. Do not immerse in

water.

CAUTION

Never allow the power supply cord to

be pulled, twisted or severely bent. Never

wrap the cord tightly around the unit.

Damage will occur at the high flex point of

entry into the unit, causing it to rupture and

short circuit. Inspect the cord frequently

for damage. Stop use immediately if

damage is visible or unit stops or operates

intermittently.

If cord or unit is damaged or does not

operate properly, return it for repair to an

authorized Conair Service representative

only. No repairs should be attempted by

the consumer.

The Microdermabrasion Facial Spa is for

household use only.

STORAGE-Important

When not in use, your unit should be

disconnected and stored in a safe, dry

location, out of reach of children. Do not

wrap line cord around unit. Allow the cord to

hang or lie loose and straight at the point of

entry into the unit.

SPECIAL PAMPERING TIPS

FOR DELICATE AREAS

THE EYE AREA

• Give special care to the eye area during your

personal facial, by lightly massaging additional

moisturizer or eye cream on eyelids and under

your eyes before you begin.

THE NECK & THROAT

• Apply your favorite moisturizer to your

entire face.

• Mist your face for only 5 minutes, following

Instructions For “Your Personal Facial”.

• Tilt your head backward so your throat is

approximately 2 inches from the facial mask.

• Mist your throat for 2 minutes. For best

results, accelerate moisturizing process by

gently turning neck from side to side.

SPECIAL USES

• Consult your physician or dermatologist

for instructions on how to best use The

Microdermabrasion Facial Spa for your

specific condition.

USER MAINTENANCE

INSTRUCTIONS

Caring for The Microdermabrasion Facial Spa

After Completing Your Facial:

• Always turn off and unplug The

Microdermabrasion Facial Spa from the

electrical outlet before cleaning.

• Let cool then empty excess water, and wipe

dry interior of the facial mask and rim

around the opening.

• Wipe the base with a clean, damp cloth,

then polish lightly with a dry one. NEVER

IMMERSE THE FACIAL SAUNA IN WATER.

• Do not attempt to repair the appliance

03PC2407 MDF2 IB 8/19/03 10:05 AM Page 2