Condeco PN41734 Condeco 4.3 inch Touch Screen User Manual Condeco Sense Proposal for Company

Download:
Mirror Download [FCC.gov]
Document ID	2308179
Application ID	Bgw34oJuE58cS0370Ey4mw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	56.42kB (705197 bits)
Date Submitted	2014-06-27 00:00:00
Date Available	2014-06-27 00:00:00
Creation Date	2014-06-02 14:27:16
Producing Software	Microsoft® Office Word 2007
Document Lastmod	2014-06-23 13:52:43
Document Title	Condeco Sense Proposal for [Company]
Document Creator	Microsoft® Office Word 2007
Document Author:	Peter Otto

Condeco User Manual for 4.3” Screen
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The RF ID belongs to category 3 receiver, and the dutyclycle is less than 10%
The RF ID could be supplied by DC 5V from adapter,which input AC 120V/60Hz, output DC 5V/1A adapter.
also could be supplied by DC 48V from POE adapter, which input 120V/60Hz, output DC 48V POE
Operating ambient temperature range:-20 to 40
Contents
User manual........................................................................................................................ 4
Equipments required: ..................................................................................................... 4
Prepare to power up 4.3” screen: .................................................................................... 4
Book a desk with 4.3” screen........................................................................................... 5
About .................................................................................................................................. 8
Condeco Room Booking ................................................................................................. 8
About Condeco ............................................................................................................... 8
Who we work with .......................................................................................................... 8
Contact ............................................................................................................................... 9
Condeco Hardware Section
Page 2 of 7
Responsibility
Name
Owner
Condeco Ltd
Author(s)
Reviewer
Approver
Phil Briffa
Version
Status
Reason for change
Date
1.0
Final
Initial Release
27 May 2014
Name
Organisation
Project
Number
Condeco Hardware Section
Page 3 of 7
User Manual for 4.3” screen
Equipments required:
1. A standard POE (48V) network connection.
2. A network cable.
Prepare to power up the 4.3” screen:
1. Prepare the POE network cable and fine the RJ45 network connector on the back
of the 4.3” scree.
2. Plug the network cable into the RJ45 connector to power the screen up.
Condeco Hardware Section
Page 4 of 7
3. Display comes up with Condeco logo. Screen powered up.
Book a desk with Condeco 4.3” screen
The following formats of RFID cards are fully compatible with Condeco 4.3” screen:
HID Prox, HID iClass, Mifare, Desfire.
1. Following with Condeco logo, the booking screen will comes up in 2-3 second.
Condeco Hardware Section
Page 5 of 7
2. On the touch screen, key in the desk ID then press the Save button.
3. After press Save, the desk ID will appear on the screen. Press Book Now to book
the desk.
4. Key in the security code or swipe the RFID card in front of the screen.
Condeco Hardware Section
Page 6 of 7
5. Desk has been booked. The person’s name will display on the screen until the time
is expired.
6. If you want to canecl the booking, press Release button. Then key in the security
code or swipe the RFID card in front of the screen. The booking will be cancel.
Condeco Hardware Section
Page 7 of 7

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 7
Language                        : en-GB
Tagged PDF                      : Yes
Title                           : Condeco Sense Proposal for [Company]
Author                          : Peter Otto
Creator                         : Microsoft® Office Word 2007
Create Date                     : 2014:06:02 14:27:16+01:00
Modify Date                     : 2014:06:23 13:52:43+08:00
Producer                        : Microsoft® Office Word 2007

EXIF Metadata provided by EXIF.tools