Controlled Entry Distributors DOL318LI4SQ Remote Controller User Manual DOLKWP318LIP4SQ Manual
Controlled Entry Distributors, Inc. Remote Controller DOLKWP318LIP4SQ Manual
Users Manual
DOLKWP318LIPSQ
318 MHz Keypad
1. Enter the “Master Code” (default is )
2. Press the button.
3. Enter for change code.
4. Enter for Master Code.
5. Enter the new “Master Code”
6. Press the button.
7. If multi-color status LED flash 3 times with green color. Meant code repeated.
STEP 2: Programming the Master Code
1
1
*
*
432
0 0
1. Enter the “Master Code” (default is )
2. Press the button
3. Enter for change code
4. Enter for the number of user code (eg. “03” for the third user code, etc).
5. Enter the new “User Enter Code”(4 digits)
6. Press the button.
7. If multi-color status LED flash 3 times with green color. Meant code repeated.
STEP 3: Programming the User Entry Code
1
1
*
*
432
0 1
1. Disconnect the power by remove the battery.
2. Press 3 6 9 keys simultaneously.
3. Power up the keypad again.
4. Release 3 6 9 keys.
5. Return to default Master Code 1 2 3 4
6. Clean all User Entry Code.
Programming the Keypad
STEP 1: Return to Default Setting
The keypad will shut down for approx. 40 seconds if your entry code is not correct
within a string of 18 digits. This will discourage an unauthorized person from trying
use random numbers to access your property.
1. Enter the “Master Code” (default is )
2. Press the button
3. Enter 2 for delete a user code
4. Enter for the number of user code (eg. “03” for the third user code, etc).
5. Press the button.
Delete the Programmed User Entry Code
ORANGE - Key Depressed
RED - Entered Correct Code and Transmitting
GREEN - Programming Mode
GREEN FLASHING (3 times) - Error During Programming Mode
Multi-color Status LED
1
1
*
*
432
0 1
User Enter Code 2 3 4 5
(Note: To reset the access code remove 9 volt battery form unit, Depress any key
on the keypad and wait 10 seconds before installing battery.
Preset Factory Codes
2 3 4 5
Send a signal to channel 1 of TX module:
# 2 3 4 5 - 2
Send a signal to channel 2 of TX module:
(access code)
(access code)
# 2 3 4 5 - 3
Send a signal to channel 3 of TX module:
(access code)
# 2 3 4 5 - 4
Send a signal to channel 3 of TX module:
(access code)
