Cotton On USA 136796 Mighty Bluetooth Speaker User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2701122
Application ID	UhI1jU0zZRkDLKenCXCbaA==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	20.87kB (260895 bits)
Date Submitted	2015-08-03 00:00:00
Date Available	2015-08-03 00:00:00
Creation Date	2015-07-22 08:27:00
Document Lastmod	2015-07-22 08:42:56
Document Title	User manual
Document Creator	Adobe Illustrator CS2

TYPO MIGHTY SPEAKER
Folded Booklet
Each page is 70mm x 70mm
FRONT
Instructions of use
Slide the Off/On switch on the speaker to the ON position.
Press and hold the Bluetooth pairing button for 2 seconds.
Tones will sound and the light will flash blue to indicate
pairing attempt.
Place your audio device in Bluetooth mode (look in the
device’s settings menu) and make it discoverable.
‘Typo Mighty Speaker’ should appear on your device.
If ‘Not Connected’, ‘Not Paired’ or similar message appears,
select ‘Typo Mighty Speaker’ to connect. If prompted for a
password, enter ‘1234’ on your device’s keypad.
Once paired, the light will glow solid blue and a
confirmation beep will sound and you can then stream
audio. If pairing is not successful, turn the power off on
the speaker and repeat the pairing procedure.
To listen to Bluetooth audio in the future, slide the Off/On
switch on the speaker to the ON position. The light will
flash blue slowly as the speaker attempts to auto-link with
the last previously linked unit in range (30 feet).
Control Bluetooth audio from your device.
Remember to turn off the speaker and your device after
listening.
NOTE: When unit is charging, the blue light will appear
solid red.
Maintenance
Place the unit on a level surface away from sources of
direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural
wood and lacquered finish. A cloth or other protective
material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild
soap and water
Do not use strong cleaning agents such as thinner or
similar materials as they can damage the surface of the unit.
NOTE:
When not in use, turn speaker OFF to save battery power.
Unit will automatically power down after 5 minutes if no
audio or bluetooth stream is detected (you will then need
to slide the power switch to OFF position.
WARNING
Lithium batteries can explode or cause burns if
disassembled, shorted, recharged, exposed to water, fire,
or high temperature & not handled appropriately
Do not place loose batteries in a pocket, purse, or other
container containing metal objects, do not mix with used
or other battery types, or store with hazardous or
combustible materials.
Store in a cool, dry, ventilated area.
Follow applicable laws and regulations for transport and
disposal.
When used in the directed manner, this unit has been
designed and manufactured to ensure your personal
safety. However, improper use can result in potential
electrical shock or fire hazards. Please read all safety and
operating instructions carefully before installation and
use, and keep these instructions handy for future
reference.
210mm
BACK
Take note of following warnings;
Charge before use – must be fully charged.
Keep away from water, all liquids, moisture and heat.
This product must be well ventilated at all times.
This product should only be connected to a power supply
as described in instructions.
This product should only be cleaned as recommended.
Keep unplugged from power source if not being used for
a period of time.
If damaged this can only be repaired by a professional
technician.
The speaker is powered by a rechargeable battery in the
speaker. Make sure to charge the speaker before using.
Connect the micro-USB plug to the USB Charging jack on
the speaker.
Connect the larger USB plug to USB AX adaptor or to a
powered USB port, such as that on a computer. The light
on the speaker will turn to solid red while charging and
turn off when fully charged. When the red light flashes or
if you start to notice sound distortion at higher volumes,
it’s time to recharge the battery.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
This device complies with Part 15 of the FCC Rules,
cause harmful interference to radio or television reception,
operation is subject to the following two conditions:
which can be determined by turning the equipment off
(1) This device may not cause harmful interference, and
and on, the user is encouraged to try to correct the
(2) this device must accept any interference received,
interference by one or more of the following measures;
including interference that may cause undesired operation. Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
Warning: Changes or modifications to this unit not
receiver.
expressly approved by the party responsible for
Connect the equipment into an outlet on a circuit different
compliance could void the user’s authority to operate the
from that to which the receiver is connected.
equipment.
Consult the dealer or an experienced radio/TV technician
NOTE: This equipment has been tested and found to
for help.
comply with the limits for a Class B digital device, pursuant
to Part 15 of FCC Rules.
FCC Information
FCC Radiation Exposure Statement
This equipment complies with the FCC RF radiation
exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
70mm

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1.1-111
Format                          : application/pdf
Creator Tool                    : Adobe Illustrator CS2
Create Date                     : 2015:07:22 08:27+10:00
Modify Date                     : 2015:07:22 08:42:56+10:00
Metadata Date                   : 2015:07:22 08:42:56+10:00
Thumbnail Width                 : 256
Thumbnail Height                : 228
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 25743 bytes, use -b option to extract)
Document ID                     : uuid:341A939AF72FE5119F13F55C4B23789F
Instance ID                     : uuid:d5ce8a7e-dc8b-4e60-90f9-1402d8f66fa6
Page Count                      : 1
Creator Version                 : 12
Container Version               : 9
Creator                         : Adobe Illustrator(R) 12.0
For                             : Microsoft, Microsoft
Title                           : MIghty Bluetooth Speaker Booklet.pdf
Bounding Box                    : -102 145 535 709

EXIF Metadata provided by EXIF.tools