Crane Payment Innovations MEICARD3B Easichoice 4 in 1 +Credit Card Bezel User Manual
MEI Easichoice 4 in 1 +Credit Card Bezel
User Manual
CASHFLOW EasiChoice 4 in 1+
Installation Guide
CASHFLOW EasiChoice 4 in 1+
Installation Guide
General Information 4 in 1 + 3 Button Bezel
The 4 in 1 + bezel kit has been designed to add a cashless RFID
payment system with Loyalty Card support to a vending machine that uses
an MEI bill validator. The 4 in 1 + is also available in a standalone version
without the validator.
The 4 in 1+ bezel replaces the bezel on the validator
To remove the validator from the vending machine:
1. Remove the four 11/32 nuts located on the back of the validator.
2. Remove the 4 screws that hold the old bezel on the validator.
Install the 4 in 1+ bezel on the validator and place the validator back
into the vending machine. Tighten the 4 nuts against the validator
mounting plate.
3. Plug the 4 in 1+ cable into the Advance 5000 socket.
Be careful not to pinch or damage the bezel cable
when installing the 4 in 1+ bezel.
A5K 4 in 1 +
See the Advance 5000 manual for installation instructions.
Contact MEI Technical Support @ 1-800-345-8172 with any questions.
Notes:
FCC ID: QP8MEICARD3B
CAUTION: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (a) This device may not cause harmful interference, and (b) this device must accept
any interference received, including interference that may cause undesired operation.
MEI 3222 Phoenixville Pike, Suite 200, Malvern, Pa. 19355
©2013 MEI Inc. www.meigroup.com
General Information 4 in 1+ 3 Button Bezel
The 4 in 1+ bezel kit has been designed to add a cashless RFID
payment system with Loyalty Card support to a vending machine that
uses an MEI bill validator. The 4 in 1 + is also available in a standalone
version without the validator.
The 4 in 1+ bezel replaces the bezel on the validator.
To remove the validator from the vending machine:
1. Remove the four 11/32 nuts located on the back of the validator.
2. Remove the 4 screws that hold the old bezel on the validator.
Install the 4 in 1+ bezel on the validator and place the validator back
into the vending machine. Tighten the 4 nuts against the validator
mounting plate.
3. Plug the 4 in 1+ cable into the Advance 5000 socket.
Be careful not to pinch or damage the bezel cable
when installing the 4 in 1+ bezel.
A5K 4 in 1+
See the Advance 5000 manual for installation instructions.
Contact MEI Technical Support @ 1-800-345-8172 with any questions.
Notes:
FCC ID: QP8MEICARD3B
CAUTION: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (a) This device may not cause harmful interference, and (b) this device must accept
any interference received, including interference that may cause undesired operation.
MEI 3222 Phoenixville Pike, Suite 200, Malvern, Pa. 19355
©2013 MEI Inc. www.meigroup.com