Crate Barrel 934 Springdale Wall Hanging Cabinet Assembly Instructions From And

: Crate-Barrel 934-Springdale-Wall-Hanging-Cabinet 934-springdale-wall-hanging-cabinet crate-barrel pdf

Open the PDF directly: View PDF .
Page Count: 1

Download
Open PDF In Browser	View PDF

SPRINGDALE WALL HANGING CABINET
HARDWARE

4 - drywall anchors

4 - screws

4 - shelf pins

1 - bracket
Missing hardware? Please call 800.606.6387 for
replacements.

TOOLS REQUIRED
Thank you for purchasing the Springdale Wall
Hanging Cabinet. This page lists all the contents
included in the box. Please take time to identify the
hardware as well as the individual components of this
product. As you unpack and prepare for hanging,
place the contents on a carpeted or padded area to
protect them from damage.
Note: 2 people are required to safely install this unit.

Phillips head screwdriver

CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.

MOUNTING INSTRUCTIONS

Wall bracket
Important Note:
with pointed
The wall mounting hardware included with this unit is intended for
side up
drywall installation only. Be sure to use hardware appropriate for
your wall type. Whenever possible, attach mounting screw directly
into a wall stud. If you are unsure about your wall type or what
mounting method you should use, consult a qualified professional or
your local hardware store.
1. Determine the wall location and place the wall bracket into
position. Make sure the pointed side of the bracket points up. Align
at least 1 hole with a wall stud if possible. Level and mark the 4 hole
locations on the wall.
2. If attaching directly into wall studs, skip to Step 4. Do not use
drywall anchor if attaching directly to wall studs.
3. For drywall installation, drill 4 pilot holes at each marked hole
location slightly smaller in diameter than the drywall anchor. Insert 1
drywall anchor into each hole until the head is flush with the wall
surface.
4. Insert 1 screw through each hole in the wall bracket and into the
corresponding anchors or studs in the wall. If attaching directly into
wall studs, be sure to use an appropriate fastener (not included). Fully
tighten each screw with a phillips head screwdriver but do not over
tighten.
5. With the assistance of another adult, lift unit into position, fitting the
angled bracket on the back of the the unit onto the wall bracket.
Make sure the unit is firmly seated in the wall bracket.
6. Insert 4 shelf pins at desired shelf height and place shelf into
position. Installation is now complete.

x4
Page 1 of 1

Made in China - r05

Customer Service 800-967-6696 | http://www.crateandbarrel.com