User Manual
USER GUIDE
2
03
Package Contents
06 09
Connectivity Specifications
Overview
04 07
Audio Control
10
Troubleshooting
Powering Phone Calls
05 08 12
Safety
TABLE OF CONTENTS
3
Crave Curve Mini Speaker
Micro USB
Charging Cable
User Guide
PACKAGE C NTENTS
4
VERVIEW
Press and hold to turn the speaker on or o.
Press and hold the + or - buon
to increase or decrease volume.
Tap (without holding) the + or -
buon to switch between audio tracks.
Charge the Crave Curve Mini speaker with the provided
USB cable and your USB charger (not included) before
rst me use.
5
Press and hold the + or - buon
to increase or decrease volume.
Tap (without holding) the + or -
buon to switch between audio tracks.
Charge the Crave Curve Mini speaker with the provided
USB cable and your USB charger (not included) before
rst me use.
Power the speaker on/o by holding the power buon.
P WERING
6
Connecon via the 3.5mm stereo cable
(non Bluetooth opon)
- Connect your device to the 3.5mm port using a stereo
audio cable.
- Play audio from any device ulizing the 3.5mm output port.
CONNECT VITY
Connecon via Bluetooth
- Hold for several seconds to Power On.
- Listen for Power On tone, followed by Bluetooth
pairing signal.
- Enable Bluetooth funcon on your device.
- Speaker will remain in pairing mode unl
located on the device list.
- Select “CRAVE Curve Mini” speaker from the device list.
Once paired, you will hear Bluetooth connected tone.
7
Connecon via the 3.5mm stereo cable
(non Bluetooth opon)
- Connect your device to the 3.5mm port using a stereo
audio cable.
- Play audio from any device ulizing the 3.5mm output port.
Connecon via Bluetooth
- Hold for several seconds to Power On.
- Listen for Power On tone, followed by Bluetooth
pairing signal.
- Enable Bluetooth funcon on your device.
- Speaker will remain in pairing mode unl
located on the device list.
- Select “CRAVE Curve Mini” speaker from the device list.
Once paired, you will hear Bluetooth connected tone.
For best sound quality:
Place the speaker base
on a hard surface.
Face the speaker in
direcon of user.
Keep the device
within speaker range.
AUDIO CONTR L
01
02
03
8
PHONE ALLS
Using built-in speakerphone and microphone
Accept/end a phone call from
your phone directly.
USB Charge voltage:
DC 5V, 0.5A
Power Output:
5W
9
Accept/end a phone call from
your phone directly.
SPECIFICATIONS
Baery size:
500 mAh
Bluetooth range:
USB Charge voltage:
DC 5V, 0.5A
Power Output:
5W
Frequency:
90Hz – 20kHz
Size:
3.07x2.36x2.31 in
66 .
10
Speaker is disconnecng from phone/tablet
1 | Move your device closer to the speaker.
2 | Power cycle the speaker o/on and reconnect.
3 | Remove any visible obstrucon between the speaker and
your device.
4 | Check for signal interference from other devices in
proximity to the speaker.
Sound Quality
1 | Check if your phone/tablet/device is in close proximity
to the speaker.
2 | Remove any visible obstrucons between the speaker and
your device.
3 | Reduce volume on the device.
TROUBLESH TING
11
Speaker is disconnecng from phone/tablet
1 | Move your device closer to the speaker.
2 | Power cycle the speaker o/on and reconnect.
3 | Remove any visible obstrucon between the speaker and
your device.
4 | Check for signal interference from other devices in
proximity to the speaker.
Sound Quality
1 | Check if your phone/tablet/device is in close proximity
to the speaker.
2 | Remove any visible obstrucons between the speaker and
your device.
3 | Reduce volume on the device.
Unable to pair the speaker with your phone/tablet
1 | Check if Bluetooth funcon is enabled on your device.
2 | Check the speaker for low baery (plug into power source).
3 | Check if the speaker is possibly paired to another device.
4 | One Bluetooth enabled device should be available for
pairing at any given me, mulple enabled devices can cause
the speaker to pair to another device without you knowing.
Volume too low/volume too high
1 | Turn volume up or down on the speaker or your device.
2 | Check if the 3.5mm cable is well connected
(non Bluetooth opon).
TROUBLESH TING
12
Fire Safety
1 | Do not aempt to repair or take the speaker apart.
2 | Do not leave the speaker in direct sunlight and/or extreme
temperatures.
3 | Do not charge the speaker in wet or damp areas.
4 | Do not leave the speaker near an open re or hot surfaces.
Read safety precauons carefully to ensure your personal
safety and to prevent property damage
Drop/Fall
1 | Do not leave unaended on any surface, vibraon of the
speaker may cause movement.
S FETY
A
13
Electrical Safety
1 | Do not expose or use the speaker in rain, moisture, humidity
or near water.
2 | Do not disassemble, break open, crush, bend, puncture,
shred, microwave, paint or insert foreign objects into the
speaker.
3 | Clean using a dry cloth only.
Disposal
1 | Never dispose of the speaker through burning.
2 | Dispose of the speaker in accordance with local baery
disposal regulaons.
Read safety precauons carefully to ensure your personal
safety and to prevent property damage
S FETY
A
14
FCC INFORMATION
FCC Radiaon Exposure Statement FCC ID: 2AN7XCM5W01
This equipment complies with FCC RF radiaon exposure limits
set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operaon
is subject to the following two condions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operaon.
Warning: Changes or modicaons to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
15
This equipment complies with FCC RF radiaon exposure limits
set forth for an uncontrolled environment.
FCC INFORMATION
( connued on the following page )
These limits are designed to provide reasonable protecon
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instrucons, may cause harmful interference to radio
communicaons.
However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which
can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interferenceby one or
more of the following measures:
16
FCC INFORMATION
Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
18
@crave.direct @cravedirect
cravedirect.com
Quesons or comments? Please contact us at support@cravedirect.com
Designed by Crave in USA.
Made in China.