Creative Labs PMT-ZZ0030 Creative HanZpad User Manual 03ZZ003000001A Back outline 040512
Creative Labs Inc Creative HanZpad 03ZZ003000001A Back outline 040512
User Manual
www.android.com Technical Specifications FCC Radiation Exposure Statement Device Operating Temperature range: 0°C to 45°C Power Adapter Operating Temperature range: 0°C to 40°C Wireless Operating Frequency: 2400 -2483.5 MHz These specifications apply to the hanZpad operating from the supplied 5V DC 2A switching power supply. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without RF restriction. Safety Information Wireless Device DECLARATION OF CONFORMITY China RoHS - Table of Disclosure Regulatory Information The following sections contain notices for various countries: CAUTION: This product is intended for use with FCC/CE certified computer equipment. Please check the equipment operating/installation manual and/or with the equipment manufacturer to verify/confirm if your equipment is suitable prior to the installation or use of the product. According to the FCC96 208 and ET95-19 Manufacturer/Importer’s Name: Creative Labs, Inc. Manufacturer/Importer’s Address: 1901 McCarthy Boulevard Milpitas, CA. 95035 Tel: (408)428-6600 declares under its sole responsibility that the product Federal Communication Commission (FCC) Interference Statement TM FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be installed with computer equipment certified to comply with Class B limits. All cables used to connect to the computer and peripherals must be shielded and grounded. Operation with non-certified computers or nonshielded cables may result in interference to radio or television reception. MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the device. Trade Name: CREATIVE Model Numbers: PMT-ZZ0030 Refer to the following information to use your product safely, and to reduce the chance of electric shock, short-circuiting, damage, fire, hearing impairment or other hazards. Improper handling may void the warranty for your product. For more information, read the warranty available with your product. • Do not dismantle or attempt to repair your product. Refer all servicing to authorized repair agents. • Do not expose your product to temperatures outside the range of 0°C to 45°C (32°F to 113°F). • Do not pierce, crush or set fire to your product. • Keep your product away from strong magnetic objects. • Do not subject your product to excessive force or impact. • Do not expose your product to water or moisture. • If your product is moisture-resistant, take care not to immerse your product in water or expose it to rain. Please read the following before using the Creative products: • Use a mains plug that is appropriate for your country or region. • To be completely disconnected from the power input, the mains plug has to be disconnected / detached from the mains. • Disconnect the mains plug when the device is expected to be unused for several days. • Place the product near a socket outlet, which is easily accessible. has been tested according to the FCC / CISPR22 requirement for Class B devices and found compliant with the following standards: Complies with IDA Standards DB00148 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including Interference that may cause undesirable operation. Permanent hearing loss may occur if the player is used at high volume. Set the volume to a safe level. You can adapt over time to a higher volume of sound that may sound normal but can be damaging your hearing. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked. The louder the volume, the less time is required before your hearing could be affected. Hearing experts suggest that to protect your hearing: • Limit the amount of time you use the player at high volume. • Avoid turning up the volume to block out noisy surroundings. • Turn the volume down if you can’t hear people speaking near you. Assembling the Power Adapter Earphones Ce matériel est conforme à la section 15 des régles FCC. Son Fonctionnement est soumis aux deux conditions suivantes : (1) Le matériel ne peut étre source D’interférences et (2) Doit accepter toutes les interférences reques, Y compris celles pouvant provoquer un fonctionnement indésirable. • When a conductive apparatus such as earphones, is used in close proximity with a CRT television or CRT monitor, the latter may emit an electrostatic discharge. This electrostatic discharge can be felt as a static shock. While this static shock is usually harmless, it is good practice to avoid close contact with CRT devices when using earphones. • Do not listen to audio on your earbuds or headphones at high volume for prolonged periods of time as hearing loss may result. For users in the United States, go to www.hei.org for more information. • Do not listen to your audio device at high volume when driving, cycling or crossing the road, especially in heavy traffic, or in any other traffic condition where such use will hinder safe travel on the roads. We recommend that consumers be extremely cautious when using this device on the road. Supplementary Information: Embedded Battery • Do not attempt to remove the embedded battery. The product must be disposed of according to local environment regulations. • Do not expose to excessive heat such as sunshine, fire or the like. CAUTION: Risk of explosion if battery is replaced by incorrect types. Compliance Manager Creative Labs, Inc. May 31, 2012 Avoid Hearing Damage WARNING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture. EMI/EMC: ANSI C63.4, FCC Part 15 Subpart B& C Complies with Canadian ICES-003 Class B & RSS-210 standards Singapore • The short wave radio frequency signals of a wireless device may impair the operation of other electronic and medical devices. • Switch off the device where is prohibited. Do not use the device in medical facilities, aircraft, refueling points, close to automatic doors, automatic fire alarms or other automatically controlled devices. • Keep the device at least 20 cm from pacemakers and other medical devices. Radio waves may impair the operation of pacemakers and other medical devices. License and Copyright The Creative Logo, HanZpad, , Zii, the Zii logo, ZiiSound, and X-Fi are trademarks or registered trademarks of Creative Technology Ltd in Singapore, China and/or other countries. The Bluetooth® word mark and logo are owned by Bluetooth SIG, Inc. Android is a trademark of Google Inc. All other trademarks are the property of their respective owners and are hereby recognised as such. Specifications are subject to change without notice. Actual contents and colour of the product may differ slightly from those pictured. Copyright © 2012 Creative Technology Ltd. All rights reserved. Version 1.00.00 May 2012
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Format : application/pdf Title : 03ZZ003000001A Back outline 040512 Creator Tool : Adobe Illustrator CS2 Create Date : 2012:05:08 14:34:11+09:00 Modify Date : 2012:05:29 19:07:43+08:00 Metadata Date : 2012:05:29 19:07:43+08:00 Thumbnail Width : 256 Thumbnail Height : 40 Thumbnail Format : JPEG Thumbnail Image : (Binary data 4896 bytes, use -b option to extract) Document ID : uuid:1F562B6B2498E111AD27A0FE9A3E918F Instance ID : uuid:6353ba84-26ec-4b48-a0ea-c52bee406ba9 Derived From Instance ID : uuid:7bc8541a-b05f-46b0-a518-28a14001f806 Derived From Document ID : uuid:BEB42EADBD95E111B521A603989113F8 Producer : Adobe PDF library 7.77 Page Count : 1 Creator : Adobe Illustrator(R) 12.0 For : Rios Tan, Creative Technology Ltd Bounding Box : -1072 370 1907 820 Container Version : 9 Creator Version : 12EXIF Metadata provided by EXIF.tools