D Link DWL700AP-A1 D-Link Air 2.4 GHz Wireless Access Point User Manual dwl900AP manual 224

D Link Corporation D-Link Air 2.4 GHz Wireless Access Point dwl900AP manual 224

User Manual Part 5

Using the Configuration Menu (continued) Antenna transmit power: you may wish to select less than 100% power for security reasons, depending its proximity to other networks Antenna Selection: Select Left, Right or both (Diversity) antenna Advanced > Filters Tools > Admin Change your password in this window. It can be up to 14 characters in length. Please keep a copy of your password in a safe place. Click Apply, if you have made any changes. Use MAC Filters to allow ordeny wireless connection to the DWL-700AP. Select Disable MAC Filters (default) to disable this feature. Select Only allow the MAC address… or Only deny the MAC address… and enter the MAC Address of the selected computer into the field above. Or you can click on the pull-down arrow 20
Disabled is the default selection for 802.1x protocol. Select Enabled to enable it.Encryption Key: Select the key length, either 64 bits or 128 bits.Lifetime: Select 5, 15, 30 minutes or 1 or 8 hours, or 1 day for the authenticationperiod. After this period expires, members of the network will have to re-logon to gainaccess to the network.Radius Server 1IP: Enter the IP Address of the Radius Server.Port: Enter the port number that your Radius Server uses for Authentication.The default setting of 1812 is the port setting for many Radius Servers.Shared Secret: Enter the Shared Secret. The shared secret must be thesame as the shared secret on your radius server.Radius Server 2: Optional. If you have a second radius server, you will input the same information as shown above.Advanced > 802.1x:20202020202121Using the Configuration Menu (continued)
Using the Configuration Menu (continued) Fig. 5.10 Tools > System The current system settings can be saved as a file onto the local hard drive by clicking Save. The saved file can be loaded back on the DWL-700AP by clicking Browse. When you have selected the settings file, click Load. Click Restore to return to Factory Default Settings. Tools > Firmware Upgrade the firmware for the Access Point. Click on the link to find upgrades to the firmware on the D-Link website at http://support.dlink.com. After you have downloaded a firmware upgrade to your local drive, click Browse. Select the firmware and click Apply to complete the upgrade. Fig. 5.11 22

Navigation menu