D Link WR510A1 DWR-510 3.75G HSUPA USB Adapter User Manual DWR 510 V0 1 Draft 2010 11 8 FCC
D Link Corporation DWR-510 3.75G HSUPA USB Adapter DWR 510 V0 1 Draft 2010 11 8 FCC
D Link >
user manual
User Manual DWR-510 V0.1 (Draft) DWR-510 HSPA USB Dongle Router User Manual -1- User Manual DWR-510 V0.1 (Draft) I. Introduction i. Overview DWR-510 HSPA USB Dongle Router – is a highly integrated wireless solution for 3G and WiFi. The demands of data communication everywhere becomes more due to the great development of 3G HSPA system. DWR-510 adopts Qualcomm MSM6290 solution. It provides up to 7.2 Mbps HSDPA, up to 5.76 Mbps HSUPA, RX antenna diversity and wireless router etc. DWR-510 is fast, reliable and easy to operate. Therefore, user can experience the new features and surf the internet everywhere by DWR-510 dongle router. ii. Features ◎HSUPA data rate up to 5.76 Mbps ◎HSDPA data rate up to 7.2 Mbps ◎UMTS PS domain data rate up to 384 kbps ◎EDGE packet data rate up to 236.8 kbps ◎GPRS packet data rate up to 115.2 kbps ◎WiFi 802.11 b/g/n ◎Share internet connection with 6 WiFi devices ◎A slide switch to select between WiFi router mode and PC USB modem mode ◎USB interface ◎Multi-color LED indicating status of network connection ◎Support Microsoft Windows XP / Vista / Windows 7 ◎Support Linux (Router mode only) ◎Support Mac OS (Router mode only) iii. Product Review ◎Modem mode Modem mode provides the 3G access only from USB interface. User needs to set the slide switch to modem mode then device will operate in 3G USB modem mode. User needs to launch connection manager utility to access 3G data transaction. -2- User Manual DWR-510 V0.1 (Draft) Modem Mode Modem Mode Switch configuration ◎Router Mode DWR-510 will become 3G / WiFi Router in this mode and can share 3G bandwidth to other devices that connect to DWR-510 by WiFi. DWR-510 allows up to 8 WiFi enabled devices to simultaneously connect to the Internet. -3- User Manual DWR-510 V0.1 (Draft) Router Mode It is recommended to choose this mode when there is no access point showed in your wireless network. Router Mode Switch configuration -4- User Manual DWR-510 V0.1 (Draft) II. Installation i. System Requirements Before you install DWR-510, please make sure your system meets the following requirements. *Desktop or Laptop or applications with USB 1.1/2.0 port *Minimum of 64MB system memory *Operating system: XP/Vista/ Windows 7 ii. Hardware Installation 1. Find an available USB 1.1/2.0 port on your desktop or laptop or other applications. 2. Plug DWR-510 USB adapter into USB port of desktop or laptop or other applications. iii. Setup: Windows XP OS If your computer is running a Windows operating system, it will automatically detect the DWR-510 after device plug into the USB port, and OS displays a “Found New Hardware” window. -5- User Manual DWR-510 1. Find out the Driver, and launch the Hardware Wizard V0.1 (Draft) 2. Please click “Yes, now and every time I connect a device” circle, and “Next>” button. -6- User Manual DWR-510 V0.1 (Draft) 3. Please click “Install the software automatically (Recommended)”, and “Next>” button 4. The Hardware Wizard will automatically install the software -7- User Manual DWR-510 V0.1 (Draft) 5. If you see the warning Windows Logo testing message, please click “Continue Anyway” 6. Please wait the software installation. -8- User Manual DWR-510 V0.1 (Draft) 7. After the “Completing the Found New Hardware Wizard” windows appear, click “Finish” button. -9- User Manual DWR-510 V0.1 (Draft) III. Using i. Modem mode Please push slide switch to “Modem” position to configure device to “Modem mode”. Device will only enable WWAN function in “Modem mode”, WiFi function will be disabled. Steps to use device in “Modem mode”: 1. Please double click “D-Link HSUPA Connection Manager” Icon to launch utility. 2. Please input “PIN code” - 10 - User Manual DWR-510 V0.1 (Draft) 3. After found WWAN Network information and signal bar, please click “connect” icon to connect to WWAN network. 4. The “Dial Up” window will appear, please wait this process to finish. 5. Now, your computer is connecting to WWAN network. You can use internet browser and other internet utility to surf the network. - 11 - User Manual 6. Menu List: 6.1 Setting 6.1.1 DWR-510 V0.1 (Draft) New 6.1.1.1 Contact It’s used for the contact information management. New -> Contact - 12 - User Manual DWR-510 6.1.1.2 Message It’s used to edit and send short message. New -> Message V0.1 (Draft) 6.1.1.3 Connection Profile It’s used to select built-in APN or modify APN setting. New -> Connection Profile 6.1.2 Connect / Disconnect It’s used to connect or disconnect to WWAN network. - 13 - User Manual DWR-510 V0.1 (Draft) 6.1.3 Router Config 6.1.3.1 Wireless Setting It’s used to modify WiFi setting, including wireless network name (SSID) and security option. Router Config -> Wireless Setting 6.1.3.2 Network Setting It’s used to modify WiFi network setting, including IP and DHCP address. Router Config -> Network Setting - 14 - User Manual DWR-510 6.1.3.3 Advanced It’s used to modify WiFi MAC filter setting. Router Config -> Advanced V0.1 (Draft) 6.1.3.4 Internet It’s used to modify APN setting for “Router mode” using condition. Router Config -> Internet - 15 - User Manual DWR-510 V0.1 (Draft) 6.1.3.5 Tools It’s used to set password for the management web page in “Router mode” using condition. The default login name and password is admin Router Config -> Tools 6.2 Edit - 16 - User Manual DWR-510 6.2.1 Contact It’s used to manage the contact information. V0.1 (Draft) 6.2.2 Message It’s used to manage the short message information. - 17 - User Manual DWR-510 V0.1 (Draft) 6.2.3 Connection Profile It’s used to manage the connection profile in “Modem mode” using condition. 6.3 Tools 6.3.1 SIM Card Lock It’s used to lock /unlock SIM card. 6.3.2 PIN Code Change It’s used to change PIN code. - 18 - User Manual DWR-510 V0.1 (Draft) 6.3.3 Network Mode It’s used to configure the WWAN network to “Auto” or “WCDMA only” or “GSM only”. 6.4 Help 6.4.1 About - 19 - User Manual DWR-510 V0.1 (Draft) ii. Router mode Please push slide switch to “Router” position to configure device to “Router mode”. Device will enable WWAN and WiFi router function in “Router mode”. Steps to use device in “Router mode”: 1. Push slide switch of device to “Router” position. 2. Enable WiFi function in your computer. 3. Turn on WiFi management tool in your computer, the default SSID of DWR-510 is DWR-510-dlnk. Please connect to it and you can start to surf the network. 4. Webpage for “Router mode” management 4.1 IP address to access management webpage The default IP address is http://192.168.0.1/ 4.2 SETUP 4.2.1 INTERNET It’s used to setup APN for 3G router. - 20 - User Manual DWR-510 4.2.2 WIRELESS SETTINGS It’s used to set WiFi SSID, Country, Channel and Security Mode. 4.2.3 NETWORK SETTINGS It’s used to set the IP address of the management webpage. - 21 - V0.1 (Draft) User Manual DWR-510 4.3 ADVANCED It’s used to set the MAC filtering rules for “Router mode” using case. 4.4 TOOLS 4.4.1 ADMIN It’s used to set the password for the management webpage. 4.4.2 SYSTEM It’s used to restore the factory default setting. - 22 - V0.1 (Draft) User Manual DWR-510 V0.1 (Draft) 4.5 STATUS 4.5.1 DEVICE INFO It’s used to show the device information. - 23 - User Manual DWR-510 4.5.2 WIRELESS It’s used to show the WiFi MAC address. V0.1 (Draft) 4.6 SUPPORT It’s the help information here. - 24 - User Manual DWR-510 V0.1 (Draft) Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. - 25 - User Manual DWR-510 V0.1 (Draft) Products with 2.4–GHz Wireless LAN Devices France L'utilisation de cet equipement (2.4GHz wireless LAN) est soumise à certaines restrictions: cet equipement peut être utilisé à l'interieur d'un batiment en utilisant toutes les frequences de 2400 a 2483.5MHz (Chaine 1–13). Pour une utilisation en environement exterieur, les frequences comprises entre 2400-2454 MHz (Chaîne 1-9) peuvent être utilisé. Pour les dernières restrictions, voir http://www.art-telecom.fr. For 2.4–GHz wireless LAN operation of this product, certain restrictions apply. This equipment may use the entire–2400–MHz to 2483.5–MHz frequency band (channels 1 through 13) for indoor applications. For outdoor use, only 2400-2454 MHz frequency band (channels 1-9) may be used. For the latest requirements, see http://www.art-telecom.fr. Wireless LAN Module’s Maximum EIRP Frequency Ranges (MHz) Indoors Outdoors 2400 MHz ~ 2446.5 MHz 10mW Not Permitted 2446.5 MHz ~ 2483.5 MHz 100mW 100mW on private property with Ministry of Defense approval. - 27 - User Manual DWR-510 V0.1 (Draft) For Taiwan 警語: 第十二條 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻 率、加大功率或變更原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立 即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線 電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之 干擾。 Note: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤 2. 系統廠商應於平台上標示「本產品內含射頻模組: CCXXXXYYyyyZzW 」字樣 - 28 -
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Author : young.fan Create Date : 2010:11:08 12:42:35+08:00 Modify Date : 2011:03:10 10:53:33+08:00 Subject : XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Producer : GPL Ghostscript 8.70 Keywords : Creator Tool : PDFCreator Version 0.9.9 Metadata Date : 2011:03:10 10:53:33+08:00 Document ID : 49705c0a-ed4e-11df-0000-e8b0ed21c411 Instance ID : uuid:fdcc11a3-2d5a-4863-8962-d8b9060ab2ec Format : application/pdf Title : DWR-510_User Manual_V0.1_Draft__2010_11_8_FCC Creator : young.fan Description : Description (x-repair) : Page Count : 27EXIF Metadata provided by EXIF.tools