DASAN Network Solutions H640GW G-PON ONT User Manual H640GW N A QIG EN 130509 V3 ai
DASAN Network Solutions, Inc. G-PON ONT H640GW N A QIG EN 130509 V3 ai
User Manual
4. Inial Web Access 1. Cauon 2. Introducon You can access H640GW through a web browser by using the inial LAN IP at ďŹrst. The detail procedure is as follows: â´ Connect LAN1 port of H640GW to your PC using Ethernet cable. â´ ConďŹgure an IP address of your PC to 192.168.1.1~254 (except 192.168.1.100). â´ Open a web browser, and enter hp://192.168.1.100:8080 in a URL ďŹeld. â´ Type âuser/userâ in user name/password ďŹeld, and log into the system. Inial page is displayed. - This unit is indoor use and all the communicaon wirings are limited to inside of the building. - Never look directly at the ďŹber TX port and ďŹber cable ends when they are powered on. - DO NOT use near water. - DO NOT place near high temperature source. - DO NOT disassemble the unit. - DO NOT operate the unit in a locaon where the maximum ambient temperature exceeds 104°F. - Open opcal connecons must use a protecve cap under all circumstances to protect against physical damage and dirt. - Avoid impact stresses when handling connectors. Physical damage to the faces of opcal connecons impairs transmission quality (higher aenuaon). - Avoid a bend radius in excess of 1.18 in for ďŹber opc links. - Check the available voltage supply. - Only connect approved accessories. - It may only be repaired by authorized service personnel. FCC CerďŹcaon Requirements TIP for Beer Wireless Communicaon You can make antennas oblique outside or inside the body by lng () and rotang () them for beer wireless communicaon as like the ďŹgure below. )(8 2*( 2VJDL(VJEF V3 GPON Opcal Network Terminal (ONT) with VoIP & Wi-Fi Informaon furnished by DASAN Networks USA, Inc. is believed to be accurate and reliable. However, no responsibility is assumed by DASAN Networks for its use, nor for any infringements of patents or other rights of third pares which may result from its use. No license is granted by implicaon or otherwise under any patent or patent rights of DASAN Networks. DASAN Networks reserves the rights to change speciďŹcaons at any me without noce. Copyright Š 2013 by DASAN Networks USA, Inc. All rights reserved. DASAN Networks USA, Inc. 5000 Research Court, Suite 700, Suwanee, GA 30024 www.dasannetworksus.com 2.3 Front View (LEDs) DASAN Networks USA, Inc. 2.4 Rear View Light PWR Green PON ALM VoIP Green Item System Memory 128MB DDR3 Flash Memory 128MB Nand Flash Uplink Interface 1 GPON port (SC/APC) Service Interface 4 10/100/1000Base-T ports (RJ45) VoIP Interface 2 FXS ports (RJ11) Wireless IEEE 802.11b/g/n compliant Bandwidth: 2.4GHz Two Transmit and Two Receive path (2T2R) Max. data rate: 54Mbps in 802.11g 300Mbps in 802.11n Security: WEP, WPA-PSK (TKIP) & WPA2-PSK (AES) LED PWR, PON, ALM, VoIP, TEL1~2, WLAN, WPS*, LAN1~4 Power Power port: AC/DC adapter, 12VDC/1.5A BBU port: For Baery Backup Unit 32 to 104°F (0 to 40°C) Humidity 5 to 90% (non-condensing) Dimensions (W x D x H) 7.48 x 5.90 x 2.44 in (190 Ă 150 Ă 62 mm) (including folded antenna) Buon On/OďŹ power, WLAN, WPS*, RESET * Wi-Fi Protected Setup, a standard that aempts to automate secure wireless network set up and connecon 3. Installaon 3.2 Mounng on a Wall 3.1 Connecng to Network (through GPON port) If necessary, you may have your ONT mounted on a wall using mounng groove and proper screws or nails. â´Loosen the screw from the opc cover. â´Pull the opc cover out from the body. â´Remove the cap from GPON port. On Groove 5.43 in (138 mm) Screw Opc Cover The system is turned on. OďŹ The system is turned oďŹ. On Register OK. The GPON port link is up. OďŹ Not registered. The GPON port link is down. On Red OďŹ Green Green WLAN Green Green Î On Register OK OďŹ Not registered On OďŹ-hook OďŹ On-hook On Wireless funcon enabled OďŹ Wireless funcon disabled Blink Î If necessay, connect a baery backup unit to BBU port instead. GPON Port Cap Item Screw ŕž OPTICAL Connect the network. â´Plug in the opc cable (SC/APC-connectorized) to connect the ONT ŕž LAN1~4 Connect PC or LAN. to the network (OLT). â´Aach the opc cover to the unit. Success (for 5 seconds) ŕž TEL1~2 Connect telephone. Disabled or process ďŹnished ŕž POWER Connect power adapter. On The 1G port link is up. ŕž ON/OFF Turn on/oďŹ the unit. ŕž RESET Reboot the unit. ŕž WPS Enable WPS process. ŕž WLAN Enable wireless funcon. present on the service port. ྡ Antenna Transmit and receive wireless packets. Link down ྡྷ BBU Connect Baery Backup Unit. present on the service port. The 100M port link is up. Orange Blink â´Plug the Ethernet cable from LAN port to PC. â´Plug the phone cable from TEL port to telephone. â´Connect the power adapter from power port to a live AC outlet. Î On On Î Î Î OďŹ Blink OďŹ Î Î 3.3 Connecng Ethernet/VoIP/Power and Enabling WLAN Î In progress Green LAN 1~4 (LNK/ ACT) 2.2 SpeciďŹcaon Status TEL 1~2 WPS H640GW RJ45 UTP Cable Power Adapter QIG (Quick Guide) www.dasannetworksus.com Î Label â Cauon Any changed or modiďŹcaons not expressly approved by the party responsible for compliance could void the user`s authority to operate this equipment. â FCC RF exposure requirements The antenna used with this module must be installed to provide a separaon distance of at least 20cm from all persons, and must not transmit simultaneously with any other antenna or transmier except in accordance with FCC mul-transmier product procedures. â User Informaon This device complies with Part 15 of the FCC`s Rule. Operaon is subject to the following to condions; 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesirable operaon. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment oďŹ and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separaon between the equipment and receiver. - Connect the equipment into an outlet on a circuit diďŹerent from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. 2.1 Package Contents â´Turn on the unit by pushing the power switch. â´Push WLAN buon to enable WLAN. â´Adjust antenna direcon for beer wireless communicaon. For informaon of how to adjust the antenna, see TIP on the last page. â´Tighten the screw on the opc cover.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : 3.1-702 Producer : Acrobat Distiller 7.0 (Windows) Create Date : 2013:05:09 10:25:48+09:00 Creator Tool : PScript5.dll Version 5.2 Modify Date : 2013:05:09 10:34:33+09:00 Metadata Date : 2013:05:09 10:34:33+09:00 Format : application/pdf Title : [H640GW_N.A]_QIG_EN_130509_V3.ai Creator : kangth Document ID : uuid:b50c7477-882a-43ec-a4e9-4a967c72a81d Instance ID : uuid:c5aad5ff-f7d7-4353-9520-2d470685057e Page Count : 1 Author : kangthEXIF Metadata provided by EXIF.tools