DYNACO USA 6803 Wireless Sensing Edge System User Manual Visio WDD vsd

Download:
Mirror Download [FCC.gov]
Document ID	1719145
Application ID	yvrKEXOOSa/flc139otPxw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	39.39kB (492355 bits)
Date Submitted	2012-06-09 00:00:00
Date Available	2012-06-09 00:00:00
Creation Date	2012-05-21 08:27:17
Producing Software	Acrobat Distiller 10.1.2 (Windows)
Document Lastmod	2012-06-08 14:47:07
Document Title	Visio-WDD User manual.vsd
Document Creator	PScript5.dll Version 5.2.2
Document Author:	spr

Reference Number:
WDD - Wireless DYNACO Dectector
USER GUIDE
WDD-US0326-12
Operating description
The WDD is a wireless sensing edge system. The sensing edge is conformed of, a conductive rubber section, sealed
wireless transmitter, and end cap. The sensing edge is installed the full width of the door in the doors soft bottom bag.
Obstacles/obstructions in the door opening will be sensed by the edge when the door comes down and makes contact
with it. The conductive rubber triggers the transmitter to send a signal to the controller to reopen the door. A very short
and rapid transmission happens only when the sensing edge makes contact with an obstacle/obstruction and will not
trigger again until that sensing edge returns back to the open state.
The system operates according to the open loop principle. The open loop operation offers a longer life for the
transmitters lithium battery, because energy is consumed only when the sensing edge makes contact with a obstacle/
obstruction, otherwise it is inactive.
Technical description for ARF6803 Transmitter
Power supply:
Frequency:
Effective radiated power:
Transmission Mode:
Battery Life:
Seal coating:
Performance:
Lithium Battery 3.6V 1.2Ah
868.3 MHz
-20dBm or 10µW
Amplitude modulation 100% or ASK
10 years no transmissions or
100,000 detections minimum
UV-cured resin
Transmission speed 2400bps NRZ
100m operating radius in open space
Technical description for ARF6838 Receiver
Power supply:
Frequency:
Bandwidth:
Reception Mode:
Relay out::
Response time of the complete system:
Operating temperature:
24vac or vdc
868.3 MHz sensitivity 0.7µV for
12dB S/N (BER0.1)
< 400kHz
Amplitude demodulation. Super heterodyne
with simple frequency change
NO - NC
< 500ms
-20°C to + 70°C
Technical description of the Sensing egde
Material:
Operating temperature:
Protection index:
Operating Mode:
EPDM 65 degrees shore A
-20°C to + 80°C
IP 67 with two sealed ends
The rubber section consists of two conductive rubber sections that each envelop a copper
wire, and an outer insulating section of non conductive rubber. Pressure lower than 10N on the
bottom of the section creates a short-circuit between the internal conductive parts and transmits
a closed contact to the extremities through the copper wires.
* DYNACO reserves the right to modify the characteristics of its products and parts without preceding notice.
DYNACO THE SAFEST CHOICE
Page 1 of 2
Reference Number:
WDD - Wireless DYNACO Dectector
USER GUIDE
WDD-US0326-12
WDD Sensing edge
The WDD transmitter wires are soldered to the sensing
edge leads and fully encapsulated in a rubber housing.
The transmitter housing is adhesively sealed to prevent
water and contaminants from effecting operation of the
system. The WDD sensing edge assembly is then
adhered in the doors soft bottom edge.
Replacement of the sensing edge should be preformed by
a certified DYNACO dealer/technician or by DYANCO
USA, Inc.
Synchronizing the system
Follow the instructions below to synchronize the transmitter to receiver.
A red LED illuminates across from connector 9 indicating that the WDD receiver is
operational and at a ready state.
1.
Lower door so that the sensing edge can be
triggered easily from the control box height. Push in the
E-stop to hold the position of door.
Note:
If control box mounted away from door, an assistant
may be need for synchronizing the system.
2.
3.
4.
Push and hold sync button using small screw driver.
The green LED will illuminate next to the red LED.
Trigger the sensing edge on door by pushing up on the
soft bottom bag. The green LED will blink.
Release the sync button.
Test the synchronization: Trigger the edge and a audible
click will be heard, also the LED on the DYNALOGIX
(DY4100) control board will illuminate.
5.
6.
FCC & IC Regulation
Model:
FCC ID
IC:
ARF-6803-E
A5Y6803
10163A-ARF6803E
Pursuant to FCC 15.21 of the FCC Rules, changes not expressly approved by DYNACO USA, Inc. might cause harmful
interference and void the FCC authorization to operate this product.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This product complies with FCC OET Bulletin 65 radiation exposure limits set forth for an uncontrolled environment.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
* DYNACO reserves the right to modify the characteristics of its products and parts without preceding notice.
DYNACO THE SAFEST CHOICE
Page 2 of 2

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Format                          : application/pdf
Title                           : Visio-WDD User manual.vsd
Creator                         : spr
Create Date                     : 2012:05:21 08:27:17-05:00
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2012:06:08 14:47:07-07:00
Metadata Date                   : 2012:06:08 14:47:07-07:00
Producer                        : Acrobat Distiller 10.1.2 (Windows)
Document ID                     : uuid:25d0bdb9-eb34-4284-aaae-97731e40fd4a
Instance ID                     : uuid:dc379b42-b9ef-49e8-a929-a1f05e64d784
Page Count                      : 2
Author                          : spr

EXIF Metadata provided by EXIF.tools