Dayi Technology MPDC01 Direct Controller User Manual 2122
Dayi Technology Company Direct Controller 2122
User Manual
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Operation Manual
Operation ManualOperation Manual
Operation Manual
1
. POWER
1.1 Uses two DC3.6V lithium batteries
(one for knee body, one for remote
controller)
* A fully charged battery, if unused for
a minimum period of one month, will
become flat.
* A new battery has to be charged
before using.
1.2 To charge
* Lithium battery charger uses
AC110~120V→60HZ, 6W or
AC220~240V→50HZ, 6W
* The micro IC will indicate the "OFF"
position, when the battery is almost flat,
but the knee joint will still be operational.
* Charging will cease automatically
when battery is fully charged.
* With the battery fully charged, the remote
controller will indicate the"ON"position
after the first movement of the knee joint.
。
1.3 Charge time
* One full charge time takes approximately
5 hours.
* The signal light will turn red when the
battery is flat and it will turn off when the
battery is fully charged or the battery is
full.
1.4 The charger is especially for the
lithium battery.
2. REMOTE CONT
ROLLER
2.1 Push button description:
* power (ON/OFF) switch.
* Auto ON/OFF.:
"ON "fully automatic
"OFF "non automatic
* Gait(+, - )”OFF " non
automatic;
the gait speed can be adjusted
by pushing the + ,- button.
2.
2
The remote controller
calculates the speed and
category level after the first
movement of the knee joint. If
it is in the "ON" position, the
IC will adjust automatically
without any further
adjustment.
2.
4
The pow
er consumption of
the battery can be
detected by the remote
controller when the knee
joint is moving.
2.
3
Conserve the battery:
* The remote controller will shut
off when the knee is not in
motion for over 3 min.
* The knee joint drive will shut off
when the knee is not in motion
for over 30 seconds.
*The effective distance for the
remote controlle is 5 meters 。
