Dayi Technology MPDC01 Direct Controller User Manual 2122
Dayi Technology Company Direct Controller 2122
User Manual
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Operation Manual 1. POWER 1.1 Uses two DC3.6V lithium batteries (one for knee body, one for remote controller) * A fully charged battery, if unused for a minimum period of one month, will become flat. * A new battery has to be charged before using. 1.2 To charge * Lithium battery charger uses AC110~120V→60HZ, 6W or AC220~240V→50HZ, 6W * The micro IC will indicate the "OFF" position, when the battery is almost flat, but the knee joint will still be operational. * Charging will cease automatically when battery is fully charged. * With the battery fully charged, the remote controller will indicate the"ON"position after the first movement of the knee joint. 1.3 Charge time * One full charge time takes approximately 5 hours. * The signal light will turn red when the battery is flat and it will turn off when the battery is fully charged or the battery is full. 1.4 The charger is especially for the lithium battery. 。 2. REMOTE CONTROLLER 2.1 Push button description: * power (ON/OFF) switch. * Auto ON/OFF.: "ON "fully automatic "OFF "non automatic * Gait(+, - )”OFF " non automatic; the gait speed can be adjusted by pushing the + ,- button. 2.2 The remote controller calculates the speed and category level after the first movement of the knee joint. If it is in the "ON" position, the IC will adjust automatically without any further adjustment. 2.3Conserve the battery: * The remote controller will shut off when the knee is not in motion for over 3 min. * The knee joint drive will shut off when the knee is not in motion for over 30 seconds. *The effective distance for the remote controlle is 5 meters 。 2.4 The power consumption of the battery can be detected by the remote controller when the knee joint is moving.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V2.3 (128-bit) User Access : Print, Copy, Extract, Print high-res XMP Toolkit : 3.1-701 About : 6726a5e0-a446-11df-0000-e7b1dba7f806 Producer : GPL Ghostscript 8.63 Keywords : Modify Date : 2010:08:13 13:32:15+08:00 Create Date : 2010:08:07 14:12:23+08:00 Creator Tool : PDFCreator Version 0.9.7 Metadata Date : 2010:08:13 13:32:15+08:00 Document ID : 6726a5e0-a446-11df-0000-e7b1dba7f806 Instance ID : uuid:b6b3e921-e372-472f-bbe2-b91913363423 Format : application/pdf Title : 2122 Creator : JessieChou Description : Page Count : 7 Subject : Author : JessieChouEXIF Metadata provided by EXIF.tools