Dell DWRFID1502 RFID 13.56MHz Wireless Module User Manual United States RFID Text
Dell Inc. RFID 13.56MHz Wireless Module United States RFID Text
Dell >
Contents
Statement
FCC Radiation Exposure Statement
WARNING: The radiated output power of this device is below the FCC radio
frequency exposure limits. Nevertheless, this device should be used in such a
manner that the potential for human contact during normal operation is minimized.
This device has been evaluated for and shown compliant with the FCC RF
Exposure limits under mobile exposure conditions (antennas are greater than 20cm
from a person’s body). This device has also been evaluated for and shown
compliant with the FCC RF exposure limits under portable exposure conditions
(antennas are within 20 cm of a person's body) when installed in certain specific
configurations. Details of the authorized configurations can be found at
https://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm by entering the FCC
ID number on the device.
Interference Statement
These devices comply with Part 15 of the FCC Rules. Operation of the devices is subject
to the following two conditions: (1) The devices may not cause harmful interference, and
(2) The devices must accept any interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If the equipment is
not installed and used in accordance with the instructions, the equipment may cause
harmful interference to radio communications. There is no guarantee, however, that such
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception (which can be determined by turning
the equipment off and on), the user is encouraged to try to correct the interference by
taking one or more of the following measures:
Relocate this device.
Increase the separation between the device and the receiver.
Connect the device into an outlet on a circuit different from that of other
electronics.
Consult the dealer or an experienced radio technician for help.
NOTE: Dell RFID devices must be installed and used in strict accordance with the
manufacturer’s instructions as described in the user documentation that comes with
the product. Any other installation or use will violate FCC Part 15 regulations.
Modifications not expressly approved by Dell could void your authority to operate
the equipment.