Dell Powered Usb Hub Setup Diagram

: Dell Dell-Powered-Usb-Hub-Setup-Diagram-111484 dell-powered-usb-hub-setup-diagram-111484 dell pdf

Open the PDF directly: View PDF .
Page Count: 2

4Connect AC power cord to hub and power outlet

Setting Up Your Powered USB Hub

CAUTION:

Before you set up and operate your Dell hub, see the

safety instructions in the Product Information Guide

TM

www.dell.com |support.dell.com Continued

Dell Host PC and Integrator sold separately1 -

0TF663A00

*0TF663A00*

1Unpack your Powered USB Hub

1. Port LEDs (6)

2. Status LED

3. Host LED

4. Service Tag Label

1 2 3

This placemat is only intended for quick reference.

Consult your Product Information Guide for complete details

2If Integrator is used, remove cover from Integrator (a)

and slide tray out (b)

1

(b)

(a)

3If Integrator is used, install retainers (a) and hub (b)

NOTE: If Integrator is not used, place hub in secured

position

(b)

(a)

4

5

1. USB Peripheral Ports (+12 V) (5)

2. USB Peripheral Port (+24 V)

3. USB Host Port

4. Power Switch

5. AC Power Port

6. AC Pass-Through Power Ports (2)

1 2

3

6

4

6Connect USB cable to hub and Host PC

Information in this document is subject to change without notice.

© 2006 Dell Inc. All rights reserved.

Reproduction in any manner whatsoever without the written permission of Dell is strictly forbidden.

Dell and the DELL logo are trademarks of Dell Inc. Dell disclaims proprietary interest in the marks and names of others.

Printed in China

7Connect peripheral cables to peripherals and then

hub when hot-plugging. NOTE: This order must be

observed or damage may result to peripherals

and/or hub

2

Cables not included. Peripherals sold separately.2 - Waste Electrical and Electronic Equipment (WEEE) Directive

In the European Union, this label indicates that this product should

not be disposed of with household waste. It should be deposited at an

appropriate facility to enable recovery and recycling.

For information on how to recycle this product responsibly in your

country, please visit: www.euro.dell.com/recycling.

February 2006

5Connect one AC pass-through power cord to hub and

Host PC. Connect other AC pass-through power cord

to hub and monitor.

NOTE: Do not connect AC pass-through connectors

to other devices without checking the Product

Information Guide

8Turn power switch on. Ensure green "Status" LED

is illuminated 9Allow Windows to install drivers for devices. Ensure

green "Host" and green "Port" LEDs are illuminated.

Amber "Port" LEDs indicate over-current

(Windows XP)

(Windows 2000)

10 If Integrator is used, slide Integrator tray in (a) and

replace cover (b)

(a)

(b)