Delta Networks VCB601 2.4G Zigbee Module User Manual VCB601 ZB01 20170718
DELTA NETWORKS (XIAMEN) LTD. 2.4G Zigbee Module VCB601 ZB01 20170718
Users Manual
VCB601‐ZB01 User Manual EFR32MG1B232F256GM48802.15.4ZigbeeModule Rev. 1.0 2017/07/18 Notice: 1. Delta Networks (XIAMEN) LTD.reserves the right to andassumesnoresponsibilityforanyerrorswithinthisdocument. 2. This document contains proprietary technical information in which is the property of the Delta Networks (XIAMEN) LTD.and shall not be disclosed to others in whole or in part, reproduced, copied, or used as the basis for design, manufacturing,orsaleofapparatuswithoutwrittenpermissionofDelta Networks (XIAMEN) LTD.Inc. change specifications detailed in this document at any time without notice, VCB601‐ZB01 User Manual Table of Content 1. PRODUCTOVERVIEW ................................................................................................................ 1 1.1. GENERALDESCRIPTION ............................................................................................................. 3 1.2. FEATURES .......................................................................................................................................... 3 2. REVISIONHISTORY ................................................................................................................... 4 VCB601‐ZB01 User Manual 1. ProductOverview 1.1. GeneralDescription The VCB601‐ZB01 is a Zigbee data collector module which can collect data from other devices WithTTL serial port and then send out data throughZigbee. This device is built in Silicon LAB EFR32MG1B232F256GM48 which is a highly integrated single‐chip low power Wireless on Chip controller. The EFR32MG1B232F256GM48combines an ARM‐Cortex M4with DSP instruction,MCUand 2.4G RF in a single chip. It provides UART interface. It also provides a bunch of configurable GPIOs which are configured as digital peripherals for different applications and controls. 1.2. Features IEEE802.15.4 in 2.4G Bandcompatible UART interface Dual 10‐pinsheader connector Standard IEEE 802.15.4 Data Rate <250kbps Modulation DSSS with OQPSK Operating Frequencies 2.400~2.483.5GHz Antenna Connector R‐SMA connector VCB601‐ZB01 User Manual 2. RevisionHistory Revision 1.0 Date 07/18‐2017 By Whom Yuanqiang.xu Remark Initialize VCB601‐ZB01 User Manual 3. Statement Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ‐ ‐ ‐ ‐ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co‐located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end‐product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co‐location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re‐evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. VCB601‐ZB01 User Manual End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2AMVP‐VCB601”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warnin VCB601‐ZB01 User Manual
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : Administrator Create Date : 2017:08:04 16:09:33+08:00 Modify Date : 2017:08:04 16:09:33+08:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Format : application/pdf Title : Microsoft Word - VCB601-ZB01_User Manual_20170718 Creator : Administrator Creator Tool : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 9.3.2 (Windows) Document ID : uuid:39188549-b4d9-47d2-81f5-085faaa7e3aa Instance ID : uuid:5f6363ce-eab7-480c-bcd3-ccc7f8a6dc97 Page Count : 6EXIF Metadata provided by EXIF.tools