Denso Wave orporated DWWB001 BHT-1300 Main Board (Bluetooth and Wireless LAN Module) User Manual DWWB001 Manualx
Denso Wave Incorporated BHT-1300 Main Board (Bluetooth and Wireless LAN Module) DWWB001 Manualx
Contents
- 1. Manual
- 2. user mnaual rev
- 3. user manual rev
user mnaual rev
DWWB001 User's Manual
LBEH5Z9UWC Installation Manual
For OEM integration only – device cannot be sold to general public.
Therefore we will ask OEM to include the following statements required
by FCC on the product and in the Installation manual Notice.
Contents
1.Land Pattern(Recommended)
2.Supply Voltage
3. Dimensions, Marking And Pin configuration
4.Notice
1.Land Pattern(Recommended Unit:mm)
2. Supply Voltage
3.
1
1
Dimensi
o
o
ns, Marki
n
n
g
3. 2 Pin configuration
4. Notice
Please describe the following warning on the final product which contains this
module.
Contains Transmitter Mobile FCC ID:?????????? Contains FCC ID:??????????
or
When installing it in a mobile equipment
Pleasedescribethefollowingwarningtothemanual.
When installing it in a portable equipment
[ModelName]
Note)
Portable equipment : Equipment for which the spaces between human body and
antenna are used within 20cm.
Mobile equipment : Equipment used at position in which the spaces between
human body and antenna exceeded 20cm.
Federal Corll■ unicatioll(Commission lnterference Statemellt
This dcvice complies with Part 15 of the FCC Rules.Operation is sutteCt tO the
following椰 √
o oondiionsI(1)lbiS de宙ce mtt not causc harmil interference,and
(2)this device must accept any interference received,including inteFference that
may cause undesired operation,
This equipment has been tested and found to comply with the lilnits for a Class B
digital device,pursuant to Part 15 ofthc FCC Rules. These limiヽ are designed to
provide reasonable protection against harlnil interference in a residential
installation.This equipment generatcs,uses and can radiatc radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmllll interferencc to radio communications. However9 there is no guarantee
that intcrfercnce wili not occur in a particular installation, If this equipment does
cause harlnfill interference to radio or television reception,which can be detcllllincd
by tuning the equipment o3『 and on,the uscr is encouraged to try to correct the
interference by one ofthc following FneaSurcsI
◆
Reorient or relocate the receiving antenna.
◆
Increase the separation bemeen thc equipment and receiver.
◆Connectthe equipmentinto an outlct on a circuit ditterent frOm that
tO which the receiver is connected.
◆Consultthe dealer or an experienced radio/TV technician for help.
FCC Caution:Any changes or modiications not expressly approved by the party
rcsponsible for compliance could void the users authority to operate this equipment.
This translnitter must not be co‐located or operating in conJunctiOn with any other
antenna or ttanslnltte■
Ldintioll E=posll]・e Si.■ teme■11
Tllls eqlliplllent cOlllplie5 ミvith FCC rattation t・ xpL■Sllfe lillllts set forth fOr all
llllCOlltrt■lled ell■ ■romlettt.1■五s eqlliplllellt sl■odd be二lstalled and Operated、 vitll
l■llut■lllln diStc■ llCe 20ctll bご郷げeen thE Ic■ cliator tt・ vOllf bOclT
FOR COl「NTRY CODE SELECiT10N rSAGE(■‐
LAN DEヽICIS〕
Notei The col■t,code Selectioll is for no盤 -1」S llloctel onlT c■ lld iS llot available
all US ll10cICl_Pご IF〔iCi reg■1lation,all WViFi prodllct lllttkctFd ill US illllst i工 [d
US operation chttule15 o■lI
FCC Ra道●
‐
■
equentt E珊}osure andttppFO■Vユl Conditio=s:
l Antelllntns must be mstLtlled lo prclvide at least 20clrL Separaticn dlst&nceむ onl τhe
tFanS■1ltting Lqntenna to the bodFofu■ er during normal operating condition
2. The antenn量 (3' uSed for ths tFanSTttltter IELuSt F10t be collocated oF OpeFating l■
COn,unctiOn with anl otheF antenn■ or tFanSttnilter l∬ lthin a host de■ ■ce.except in
accorclance lrith FCC ttulマ i‐ transElttter pFOduCt proceduFe3.
3 0nly those ante■ na=椰Fith=ane type and lesEer galn f』 ed undeF thiE FCC ID nullllbeF
can be used、「
ith this tte、電ce_
4 The Fegultntory label on the inal sFStem must include the■ tLtiement:・ =ContninI FCC
I]D:PZttWYWVB001 andUor IC:1551C‐ Dマ
「W「B001 or using electFOnlC labellllg IIllttthOd
aS dDCmented m KDBTS4743.
5 The rlnal slstem inI●
『
晨tOr IIIlugt ensl】 Fe there is■ o instructlon provittd in the user
nlュnual or cll]tolller docllil■ entation inぬ cating holv to insta1l or remove the translnitter
nlodule except such虚 ●
Tlce has iェpleIIlented tlvo■rals authentication betiveen IIlodule
and the host sTsteIEL.
6 The inal ho5t manualsh■ 1l include the fo理o■■ng regulatory statelnenti
Thi=etulpment has been tesl and found lo c● mptt Fith the linits for a Class B ttgltal
device.pttrsuant to Paコ■ 15 of FCC Rule=.Tlle■ e ll■lits ttre designed to provide
rea50nable protection against haFnlill inteFference in a residential installatlon.This
equiFInent geneFate=,uses ttnd can Fattate rtttto fl・ ●
quen等,energI If not installed
and used in accordttnce lvith the instFuCtiOn3_it JnaF ca■ ]● harmful interference to
radb coEIIIluniCation= Holveve二 there is no guarantee that inte■ ference lマ 量1ュot occur
i.■ a particul.■ r installation lf thi■ equipment does cause harmmlinterference to radlo
or teleT蟄 lon receFtiOn whl.・h can be deternined by tuning the equipmenl off and on.
the uSeF iS enCouFaged lo tFV and CorFeCt the int● rfe■tence by one or m● Ire of the
follo■ving lneasures:
―
Reorient or Fe100■te the recei、ing antenna
―
IncreaEe the cLstance betwfttn the equipllllent and the re優 》iver
―
Connect the equlp■ lent to outlet on a circuil dL田 erentむoIEL that to lャ hch the FeCeiVer
ls comected.
¨
Consull the dettler or ttn etterienCed radioFTl technician for help
Thi■ device complles with Parl 15 of the FCC Rules.OpeFat10n is subiett tO the
following tTo contttionsI(1l Ths device mal not cause harlllful inteFference,and tE}
this del■ ce nlusl accept any inte=ferlence receilttd. including interfeFenCe thttt maF
catse unde」 red operation,
Cnnada― IndustrT Canada
Operatlon is sutteCt tO the following two conditions:{1)ths de宙 ce IIlay■ ot cause
interfererLce,and(2'thiE device must accept an「 inte■ference.incluぬ ng inteばerence that
nlaI Cause und爵=ired opeFatiOn on this de宙 ce
L` utilttatiott de ce CLsPocitirest auton3■e seulelnent aux condlilon3 suivintes(1'重 ne dOit
pas produiFe de bFOu旦建age et(2)1 ・
utilisateuF du dlspositiF dolt itFe pFさt tl accepter tout
broulllage radiorlectrique re.メ ■
, mさlIIte si ce brouittage est susceptible de c● mpFOlnettre le
fonctionne=Lent du diEPos董 ゴ
To reduce poteュtial radio inTeFfeFenCe lo otheF u]erS,the antenna type and its gttn shoul■
be 30 ChOSen that the eq饉 valent isotFOpicallド rattated poweF'EIRPlii not l■ ore than that
lrequむed foF SuCCessful coEl■ lunication_
Cautioni ExposuFe tO Radio FFequencI Radiatlon
To comply lrith RSS 102 RF exp● sure comphance requiFements,for IElobile codguFations,
R separation di=tance of at least 20 cm must be mRmtained between the antenna of this
device■nd all per3o■3_ThiS detce muE‐ t not be co‐ located or opeFat撻g in coniunctlon wiIIh
ant other antenna oF tFtq n3n■ltte五
Systellll inte『 atOrs inu_ql include the IC I]D on the end pFOduCt_
I(で 警語
lr型言
1「 11島 格主
性
功
・
11"織 11'モ ■
111計=ヽ ■
司。
■
11式 博
層│:塙 lt得=慮 せT輩11・ ■目■時
t式量
'「 :事 it計主
持■■動
1潰
│ほ 疇
■
射
躊
it聾,11籠 覇│:俸 撃
:警■
F十■■
・
T響 圭
■
111『 :ギ 警
環盲
丁
捧
T辱 嫌摯
F ri F「 停
署
ヽ
■
■
ギ
'Ⅲ 攀
丁1■ 時
青
掲
確
■
FF ttTき■
11督 .■ 1■ ■
1燿 │■ 燿デ
ト
It毒 111■1情 量■
率
町
■
:ト
嘔
ギ
!萱 1占 法
::誉す:.=:ヽ ■
│■ ■
等
1■躍
11境1豊 射
Lll賞■
督
=‐ ,資
‡
││:[:キ 童■ォニ
往
「
与慎規す
:it組 ま
ギ
t‖│テ 与
童
■
■
■
チ
轟
:it'■キ
t手意
│ギ十
‡
■
品
Fき キ
=「1壌 :・ (1懲阻
wyLPD22Zべ │ヽさ
C IIDI す
i{