10.3.1.2 Packet Tracer Skills Integration Challenge Instructions
10.3.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions
10.3.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions
User Manual:
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
Packet Tracer – Skills Integration Challenge Topology Addressing Table Device Interface IP Address Subnet Mask RA G0/0 192.168.1.1 255.255.255.0 RB G0/0 192.168.1.2 255.255.255.0 G0/0 192.168.1.3 255.255.255.0 S0/0/0 209.165.200.225 255.255.255.252 RC Scenario In this Skills Integration Challenge, your focus is OSPFv2 advanced configurations. IP addressing has been configured for all devices. You will configure OSPFv2 routing with passive interfaces and default route propagation. You will modify the OSPFv2 configuration by adjusting timers and establishing MD5 authentication. Finally, you will verify your configurations and test connectivity between end devices. Requirements Use the following requirements to configure OSPFv2 routing on RA and RB: - OSPFv2 routing requirements: Process ID 1 Network address for each interface Enable authentication for area 0 - OSPF priority set to 150 on the LAN interface of RA - OSPF priority set to 100 on the LAN interface of RB - OSPF MD5 authentication key ID of 1 and MD5 key “cisco” on the LAN interfaces of RA and RB - Set the hello interval to 5 - Set the dead interval to 20 Use the following requirements to configure RC OSPFv2 routing: - OSPFv2 routing requirements: Process ID 1 © 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2 Packet Tracer – Skills Integration Challenge Network address for the LAN interface Enable authentication for area 0 Set all interfaces to passive by default, allow OSPF updates on the active LAN Set the router to distribute default routes - Configure a directly attached default route to the Internet - OSPF priority set to 50 on the LAN interface - OSPF MD5 authentication key ID of 1 and MD5 key “cisco” on the LAN interface of RC - Set the hello interval to 5 - Set the dead interval to 20 Note: Issue the clear ip ospf process command on RC if the default route does not propagate. Verify your configurations and test connectivity - OSPF neighbors should be established and routing tables should be complete. - RA should be the DR, RB should be the BDR. - All three routers should be able to ping the web server. © 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 2 Language : en-US Tagged PDF : Yes Author : Betty Staerk Creator : Microsoft® Word 2016 Create Date : 2016:12:20 14:12:33-07:00 Modify Date : 2016:12:20 14:12:33-07:00 Producer : Microsoft® Word 2016EXIF Metadata provided by EXIF.tools