10.3.1.2 Packet Tracer Skills Integration Challenge Instructions

10.3.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions

10.3.1.2%20Packet%20Tracer%20-%20Skills%20Integration%20Challenge%20Instructions

User Manual:

Open the PDF directly: View PDF PDF.
Page Count: 2

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 2
Packet Tracer – Skills Integration Challenge
Topology
Addressing Table
Device
Interface
IP Address
Subnet Mask
RA
G0/0
192.168.1.1
255.255.255.0
RB
G0/0
192.168.1.2
255.255.255.0
RC
G0/0
192.168.1.3
255.255.255.0
S0/0/0
209.165.200.225
255.255.255.252
Scenario
In this Skills Integration Challenge, your focus is OSPFv2 advanced configurations. IP addressing has been
configured for all devices. You will configure OSPFv2 routing with passive interfaces and default route
propagation. You will modify the OSPFv2 configuration by adjusting timers and establishing MD5
authentication. Finally, you will verify your configurations and test connectivity between end devices.
Requirements
Use the following requirements to configure OSPFv2 routing on RA and RB:
- OSPFv2 routing requirements:
Process ID 1
Network address for each interface
Enable authentication for area 0
- OSPF priority set to 150 on the LAN interface of RA
- OSPF priority set to 100 on the LAN interface of RB
- OSPF MD5 authentication key ID of 1 and MD5 key “cisco” on the LAN interfaces of RA and RB
- Set the hello interval to 5
- Set the dead interval to 20
Use the following requirements to configure RC OSPFv2 routing:
- OSPFv2 routing requirements:
Process ID 1
Packet Tracer – Skills Integration Challenge
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 2
Network address for the LAN interface
Enable authentication for area 0
Set all interfaces to passive by default, allow OSPF updates on the active LAN
Set the router to distribute default routes
- Configure a directly attached default route to the Internet
- OSPF priority set to 50 on the LAN interface
- OSPF MD5 authentication key ID of 1 and MD5 key “cisco” on the LAN interface of RC
- Set the hello interval to 5
- Set the dead interval to 20
Note: Issue the clear ip ospf process command on RC if the default route does not propagate.
Verify your configurations and test connectivity
- OSPF neighbors should be established and routing tables should be complete.
- RA should be the DR, RB should be the BDR.
- All three routers should be able to ping the web server.

Navigation menu