Designer Floodlight DF7 Submittal Data Sheet VPZ210AT 210 G Cut

User Manual: VPZ210AT

Open the PDF directly: View PDF .
Page Count: 3

Download
Open PDF In Browser	View PDF

Job:
Type:
Notes:

Designer Floodlight
DF7 - 7"

Page 1 of 3
The Philips Gardco Designer Floodlight DF7 is a flood luminaire with a choice of (5) precision faceted optical
systems. Each is designed to provide a specific distribution and sharp cutoff of stray light. The contemporary
soft form diecast housing is available in a variety of finishes creating compatibility with most architectural
and landscape elements. The high strength diecast aluminum knuckle features an integral splice compartment
eliminating the need for a supplementary junction box and thereby permitting closer to grade mounting.

PREFIX

MOUNTING

DISTRIBUTION

WATTAGE

VOLTAGE

FINISH

OPTIONS

Enter the order code into the appropriate box above. Note: Philips Gardco reserves the right to refuse a configuration. Not all combinations
and configurations are valid. Refer to notes below for exclusions and limitations. For questions or concerns, please consult the factory.

PREFIX

MOUNTING

DF7

C

Stub-up Conduit Mount. For direct mounting to (2) 1/2" (1.27cm) or 3/4" (1.91cm) GRC or IMC conduits. No j-box required. Must use factory supplied
mounting insert when setting stub-ups.

J

J-Box Mount. For mounting into 1/2" (1.27cm) hub. Also suitable for direct surface mount to walls or ceilings when fed by EMT, BX, SJO, NM, etc.
(For surface mount over outlet box, specify W or W90 mount).

W
WMB

Wall Mount Bullhorn. For mounting over (not to) a 4" (10.16cm) recessed outlet box. Provides full axial 180° vertical and 358° rotational aiming.
Mounts direct to wall. Surface structure must be suitable to support the assembly. Outer end of WMB must be in the “straight up” position, as
shown in diagram on opposite page. Luminaire mounts with the knuckle below the body of the luminaire only.

W90

Wall Arm Mount. For mounting over (not to) a 4" (10.16cm) recessed outlet box. Provides full axial 180° vertical and 358° rotational aiming range.
Mounts direct to wall. Surface structure must be suitable to support the luminaire. When mounted in wet locations, luminaire must be mounted as
shown in diagrams on page 2. In damp or dry locations, arm assembly may be inverted.

ST
SM

DISTRIBUTION
HFL		
VFL			
HSP		
NSP		

Wall/Ceiling Canopy Mount. For mounting over (not to) a 4" recessed outlet box. When mounted on vertical surface, provides vertical aiming from
straight down to 100° up from nadir. When mounted on a vertical surface, long axis of luminaire must be horizontal (+/-30°). Mounts directly to wall or
ceiling. The surface structure must be suitable to support the luminaire. Only suitable for use on non-combustable surfaces.

Horizontal Flood
Vertical Flood
Horizontal Spot
Narrow Spot

Stanchion Mount. 18" (45.72cm) stanchion for in-ground concrete burial mounting.
Surface Mount Stanchion. For mounting to 18" (45.72cm) stanchion pole assembly.

WATTAGE
Pulse Start MH
Magnetic Ballast
High Pressure Sodium
Magnetic Ballast

E

100MH3

70MH

200MH1 E
175PSMH1,2 E

70HPS

100HPS

Wattages marked with Circle “E” meet federal energy efficiency standards applicable to 150 watt
through 500 watt metal halide luminaires only.

VOLTAGE
120
208
240
277
347
UNIV3

Notes:
1. Utilizes mogul based lamps (T15, E18 or E28). Available with VFL, HSP, and NSP distributions only.
Not available with PCB, POLY, F or ESB options.

2. Not available in 347V.
3. Not available in 480V.

© 2016 Philips Lighting Holding B.V. All rights reserved. Philips reserves the right to make
changes in specifications and/or to discontinue any product at any time without notice or
obligation and will not be liable for any consequences resulting from the use of this publication.
philips.com/luminaires

79115-73/0511

150HPS

Designer Floodlight
DF7 - 7"

Page 2 of 3
FINISH
BRP
BLP
WP
NP
BGP
VP		
OC		

		

		

OPTIONS
PCB5
BD6		
CH6
POLY5,7,11
F5,8			
ESB9
WG10

Bronze Paint
Black Paint
White Paint
Natural Aluminum Paint
Beige Paint
Verde Green Paint
Optional Color Paint
Specify RAL designation
ex: OC-RAL7024.

Button Type Photocontrol
Barn Doors
Cutoff Hood
Polycarbonate Shield
Fusing
Extended Splice Box
Wire Guard

Notes:
5. Not Available with 175PSMH or 200MH.
6. Barn Doors (BD) and Cutoff Hoods (CH) are painted to match the luminaire.
Either can be used concurrently with the POLY option.
7. Not Available with WG option.
8. 120V through 277V only.
9. Supplied standard with 175PSMH and 200MH luminaires. Not available for use as
additional splicing volume with175PSMH or 200MH luminaires.
10. Not Available with BD, CH and POLY options. Field Installable.
11. Polycarbonate lenses carry a 1 year warranty only.

SC		
Special Color Paint
		 Specify. Must supply color chip
.

ADDITIONAL MOUNTING ACCESSORIES
PTA Pole top 2 3/8" (6.03cm) tenon adapter
TAB Twin arm bracket for use with ST or PTA
PT2 Pole top 2 3/8" (6.03cm) tenon adapter for twin back to back luminaire mounting.

SPECIFICATIONS
HOUSING: A single-piece aluminum housing is die cast in a soft barrel form.
A one piece extruded gasket mates with door frame.
DOOR/LENS ASSEMBLY: A heat and impact resistant 3/16” (.48cm)
tempered glass lens and one piece silicone gasket are mechanically secured to
door frame.
KNUCKLE: The die cast aluminum knuckle features an integral splice
compartment. A single captive 3/16” (.48cm) stainless steel allen-head bolt
and stainless steel nut securely lock the knuckle aiming teeth in 5° increments.
An opposite cover plate is removable for access to splices. The knuckle
assembly is fully gasketed.
OPTICAL SYSTEM: The wide flood, vertical flood and horizontal
spot optical systems are homogenous sheet and extruded aluminum,
electrochemically brightened, anodized and sealed. The narrow spot reflector is
hydroformed faceted Alzak ® aluminum.

DF7 Splice
Compartment
Capacity

Standard Extended
Units Splice Box

175PSMH
and 200MH
Units

#12 AWG Conductors12

5

9

5

#10 AWG Conductors12

3

7

3

12. Including ground.

ELECTRICAL: HID UNITS: Each high power factor ballast is the separate
component magnetic type capable of providing reliable lamp starting to
-20°F/-29°C.
LAMPHOLDER: The pulse rated socket is glazed porcelain with nickle
plated screw shell. All sockets are medium base except 175PSMH and
200MH units.
FINISH: Each luminaire receives a fade and abrasion resistant,
electrostatically applied, thermally cured textured, polyester powdercoat finish.
LABELS:  All luminaires bear UL or CUL (where applicable) Wet
Location labels.
WARRANTY: Philips Gardco luminaires feature a 5 year limited
warranty. See Warranty Information on www.sitelighting.com for complete
details and exclusions. Polycarbonate lenses carry a 1 year warranty only.

DF7 Pole Loading Data
Single Luminaire on PTA Adapter

1.3 ft2/.12m2

Twin Luminaires on PTA Adapter

1.9 ft2/.18m2

Twin Luminaires on TAB Adapter

2.8ft2/.26m2

© 2016 Philips Lighting Holding B.V. All rights reserved. Philips reserves the right to make
changes in specifications and/or to discontinue any product at any time without notice or
obligation and will not be liable for any consequences resulting from the use of this publication.
philips.com/luminaires

79115-73/0511

EPA

Designer Floodlight
DF7 - 7"

Page 3 of 3
DIMENSIONS AND MOUNTING
16.00"
40.64cm
9.00"
22.86cm

180°
358°

DF7-C

13.38"
33.99cm

70-150w
units

9.00"
22.86cm

(2) DF7 (Luminaires only)*

9.50"
24.13cm
29.19"
74.14cm

36.00"
66.04cm

TAB - Twin Arm
Bracket*

PTA - Pole Top
Adaptor*
RSA4 Pole with 2 3/8"X 4" Tenon
(6.03cm X 10.16cm) (Specify Height)

ST-18" Stanchion*
24.00"
60.96cm

* Order mounting accessories separately.

18".00

3.00"
7.62cm

DF7-W90

0.63"
1.60cm

RSA4 Pole with 2 3/8"X 4" Tenon
(6.03cm X 10.16cm) (Specify Height)

2.00" -12.00"
5.08cm - 30.48cm
ST-18" Stanchion*

2.50"
6.35cm

DF7WMB

PT2 - Twin Pole Top
Adaptor*

DF7-ST

ø 7.00"
17.78cm

45.72cm

6.90"
17.53cm

13.38"
33.99cm

175PSMH and
200MH units
7.00"
17.78cm

1.9"
4.826cm

DF7-J

16.00"
40.64cm

DF7-W
3.54"
8.99cm
5.00"
12.70cm

© 2016 Philips Lighting Holding B.V. All rights reserved.
Philips reserves the right to make changes in specifications
and/or to discontinue any product at any time without notice
or obligation and will not be liable for any consequences
resulting from the use of this publication.
philips.com/luminaires
79115-151/0511 12/16 page 3 of 3

ø 7.00"
17.78cm

PTA - Pole Top
Adaptor*
11.88"
30.18cm

4"
10.16cm

6.00" 16.24cm
RSA4 Pole with
2 3/8"X 4" Tenon
(6.03cm X
10.16cm)
(Specify Height)

Philips Lighting, North America Corporation
200 Franklin Square Drive, Somerset, NJ 08873
Tel. 855-486-2216
Philips Lighting Canada Ltd.
281 Hillmount Rd, Markham, ON, Canada L6C 2S3
Tel. 800-668-9008



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Author                          : Gardco Lighting
Create Date                     : 2017:02:06 14:13:28-05:00
Modify Date                     : 2017:02:07 16:53:32-05:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Instance ID                     : uuid:1cb9e17e-47e0-f649-8384-ba96d7850ab0
Original Document ID            : adobe:docid:indd:b3c0988e-593a-11df-a260-8ee1c6c53177
Document ID                     : xmp.id:ad4a5840-5a03-481c-a327-7a2ed11e095f
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:915df2cc-9589-4f65-bdc9-c29b2e4ec5af
Derived From Document ID        : adobe:docid:indd:81546974-5340-11e0-913d-9f967606a1b8
Derived From Original Document ID: adobe:docid:indd:b3c0988e-593a-11df-a260-8ee1c6c53177
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2014 (Macintosh)
History Changed                 : /
History When                    : 2017:02:06 14:13:28-05:00
Metadata Date                   : 2017:02:07 16:53:32-05:00
Creator Tool                    : Adobe InDesign CC 2014 (Macintosh)
Format                          : application/pdf
Title                           : Designer Floodlight - DF7 - Submittal Data Sheet
Creator                         : Gardco Lighting
Producer                        : Adobe PDF Library 11.0
Trapped                         : False
Page Layout                     : SinglePage
Page Count                      : 3

EXIF Metadata provided by EXIF.tools