33 846 01_VTG_400_label_Rev A_101204_ VTG 400/400D 01 A VTG400 101504
User Manual: VTG 400/400D
Open the PDF directly: View PDF 
.
Page Count: 1
| Download | |
| Open PDF In Browser | View PDF |
VTG 400, VTG 400D Video Adjustments Test pattern selection buttons Depending on the currently selected video rate, press the Video Test Pattern and selection buttons to select from up to 28 different video test patterns. The LCD displays the newly selected test pattern’s name for 3 seconds before returning to the previous menu. Refer to the test pattern chart in Appendix A of the user’s manual for the table of available test patterns and their features. Video output range button Press the Video Range button to select from among eight output range categories. Video output rate buttons Press the and Video Rate buttons to select an output rate for the chosen output range. The output rates are displayed two-at-a-time on the LCD. After choosing the desired rate, press the Select button to activate the highlighted rate. Test pattern invert /special function button Press the button to toggle the selected test pattern between normal and inverted (special) state (when available). Video level adjustment buttons Use the and buttons (next to pattern name) to adjust the test pattern’s video level between 0% (0 IRE) and 100% (100 IRE), when available. Audio Adjustments Scope trigger cursor buttons Menu Adjustments Press the and selection buttons to move the trigger point between lines (y-axis) and press the and selection buttons to move the trigger point between pixels (x-axis) on the current line. Press the Menu and Next buttons to navigate through the menus. Use the four arrow selection buttons adjacent to the LCD to make changes to the settings. Scope Trigger Adjustments Scope trigger shape button Press the Shape button to toggle the onscreen cursor’s shape between crosshairs (useful for locating the cursor on the display screen) and single pixel (useful for locating the cursor on the oscilloscope screen). Scope trigger hide button Press the Hide button to toggle the cursor on (visible) and off (hidden). Quick Select Preset Buttons Up to four video and/or audio settings can be saved by pressing one of the four Quick Select buttons for about 2 seconds until the Quick Select setup menu appears. 1. Press the and on-screen buttons to select Audio settings, Video settings, or All settings (Audio and Video). 2. Press SAVE to save the setting(s) to the Quick Select button or press CANCEL to cancel the operation and not save the setting(s) to the Quick Select button. Signal type selection button Recalling a Preset The VTG 400/400D can selectively output seven different audio signal formats: pink noise, white noise, sine wave, square wave, frequency sweep, polarity test, and sine burst. Press the desired Quick Select button to recall the stored settings. The RMS audio output level for each audio signal type is selected from a range of values using the or Level buttons. Audio frequency selection buttons The frequency for each audio signal type is selected from a range of values using the or Audio Frequency buttons. The following frequency adjustments are available for the signal types below: • Sine wave and sine burst: 20 Hz - 20 kHz in 1/12 octave steps • Square wave: 20 Hz - 5 kHz in 1/12 octave steps • Frequency sweep speed: 1 - 120 seconds • Audio level units: dBu or dBv • Output 2 enable: left & right channel output, left output, or right output • Burst interval (cycles per interval): from 00001 to 65535 • Burst on (cycles per burst): from 00001 to 65535, must be < or = to burst interval • Frequency sweep start freq.: 20.0 Hz to 19.0 kHz • Frequency sweep ending (stop) frequency (21.2 Hz to 20.0 kHz) • Frequency sweep format: logarithmic (default) or linear • Frequency sweep direction: low- to-high (start freq. to stop freq.) (default) or high-to-low (stop to start) • Audio mute: on or off (default) • Square wave automatic attenuation: on (autoattenuate to -40 dBu) or off (default) Button Lock Mode Press and hold the Signal Type and Test Pattern buttons simultaneously for 2 seconds to enable/ disable the top panel buttons. Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 135 Joo Seng Road, #04-01 PM Industrial Building Singapore 368363 +65.6383.4400 Fax +65.6383.4664 RES: VGA 640x480 FRQ: 31.50kHz 60.00Hz PAT: Fine Crosshatch SIG: Pink noise FRQ: N/A LEV: -10 dBu 245mV MENU AUDIO SETUP Audio Setup menu Video Setup menu • RGB sync format: RGBHV (default), RGBS, RGsB, or RsGsBs Audio level selection buttons www.extron.com Power on Daisan DMJ Building 6F 33-846-01 3-9-1 Kudan Minami Rev. A Chiyoda-ku, Tokyo 102-0074 Japan +81.3.3511.7655 10 04 Fax +81.3.3511.7656 Printed in USA MENU VIDEO SETUP MENU ADVANCED SETUP MENU NEXT EXIT MENU Press "NEXT" button MENU • Raster border: 1-pixel white border on or off (default) • On-screen display: on or off (default) • Autosequence mode: on or off (default) • Autosequence interval (display period per test pattern): 15 sec. (default), 30 sec., 60 sec. • RGB color channel enable: enable (on) or disable (off) red, green, and/or blue channels (default = all channels on) Advanced Setup menu • Timeout interval (for screensaver): 5 (default), 10, 15, or 30 minutes, or never • Screensaver mode: blank (black screen, default), or cycle (through test patterns in 4-second intervals) • LCD display contrast: level 000 through 063 • System reset (to default settings): yes or no; if yes is selected, a confirmation menu appears. Custom rates are not affected or overwritten during reset.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Page Count : 1 Page Mode : UseNone Page Layout : OneColumn XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:c387d4b3-afc3-4011-8a0a-feb6c0c0453d Producer : Acrobat Distiller 6.0 (Windows) Keywords : 33-846-01, rev. A, 10/15/04 Create Date : 2004:10:15 15:13:23-07:00 Creator Tool : Adobe Illustrator(R) 11 Modify Date : 2004:10:15 15:18:13-07:00 Metadata Date : 2004:10:15 15:18:13-07:00 Document ID : uuid:2f5605c5-39e7-4f7e-96f7-e0862d3bfab8 Format : application/pdf Title : 33-846-01_VTG_400_label_Rev A_101204_final.eps Creator : E. Lassanyi, T. Terracina Description : Extron VTG 400, VTG 400D product label, rev. A Author : E. Lassanyi, T. Terracina Subject : Extron VTG 400, VTG 400D product label, rev. AEXIF Metadata provided by EXIF.tools