44464 Inst
2017-08-22
: 44464-Inst 44464-inst images 714 p4dbimg
Open the PDF directly: View PDF 
.
Page Count: 2
Components and Hardware List
Riverside
Furniture Made in Viet Nam
Page 1 of 2
44440 Tv Console
email:info@riverside-furniture.com
Entertainment
Assembly Instructions
1pc. 4pcs.
E F
A B C D
16pcs. 16pcs.
Breakfront TV console
Adjustable
Leveler
Step 1
E
F
Step 2
Adjustable Shelf
Support Screw #3 x 5/8
Large Shelf Small Shelf Shelf support
4pcs.2pcs.
Juniper
Anti-Tip Restraint
Kit
G
Anti-Tip Restraint
Kit (attached to back)
2 pcs.
Note:
1. The four Small Shelves (C) have been installed for shipping. These are secured using the
Screws (F) underneath the shelves. In order to move the Shelves to a different location, using
your Phillips Screwdriver, remove the screws and move the Shelf Pins and Shelves as desired.
2. Install the Wood Shelf Supports (D) into the notches at the sides of the middle section. Place the
Large Shelves (B) onto the Shelf Supports.
The Levelers located underneath the Base can be adjusted if necessary to compensate for uneven
flooring.
Be sure to check all packing material carefully for small
parts, which may have come loose inside the carton
during shipment.
1. Temporarily locate the furniture to near it's final location in the room next to a wall. Locate a
wall stud behind your furniture and also mark the stud's location on the back of your furniture.
2. Firmly attach one bracket to the stud approximately 2" below the top of the furniture with the
2 inch long Wood Screws provided. It may be necessary to drill 3/32 dia. pilot holes for the
screws.
3. Firmly attach the other bracket onto a solid, structural part on the back of the furniture using
the 5/8 inch long Wood Screws. It may also be necessary to pilot bore for these screws.
4. Move the furniture into its final position, taking care to line up the wall bracket with the
furniture bracket. Thread a strap through the bracket as shown in the illustration. Tighten strap
until snug but do not over tighten.
Caution: Riverside Furniture Corp. assumes no liability for improper installation or excessive
loads placed on screws, brackets or straps. Failure to detach this restraint before moving
furniture may result in personal injury and property damage.
Warning: This tip-over restraint is not to be a substitute for proper adult supervision. Do not
allow children to climb on furniture. Items left on top of the TV and furniture, such as toys,
remote controls and treats might tempt young children to climb. Push the TV as far back as
possible from the front of its stand. Place electrical cords out of a child's reach, and teach
children not to play with the cords.
email: info@riverside-furniture.com
FURNITURE
Riverside
Approximately
2"
Wall Stud
5/8 inch
Screw
2 inch
Screw
Anti-Tip Hardware
Installation Instructions
Install screws
through the small
hole in brackets
Notice: Riverside Furniture Corp. recommends that steps be taken for certain furniture items to
prevent or minimize the risk of tip-over. This furniture is equipped with Tip-over Restraint
Hardware for use to minimize this risk, if used. Please follow below installation steps. Riverside
Furniture Corp. recommends that parents and guardians periodically visit the U.S. Consumer
Product Safety Commission (CPSC) website at http://www.cpsc.gov/ and stay up to date on all
issues related to children's product safety.
Page 2 of 2
