DirecDoor Installation Guide 460960001F

• Preface
  • Conventions used in this document
  • Safety terms and symbols
• Chapter 1 Introduction
  • Product overview
  • Specifications
• Chapter 2 Installation Planning and Mounting
  • Getting started roadmap
  • Safety
    • Radio interference
    • Electrostatic Discharge (ESD) precaution
  • General installation rules
  • Observing noise prevention procedures
    • Signal transmission
    • Cable length
    • Cable routing
  • Mounting
    • Mounting and handling guidelines
    • Mounting instructions
  • Determining power requirements
• Chapter 3 Power
  • Introduction
  • Device addressing
    • Picture Perfect
    • Facility Commander Wnx
  • Connector and LEDs
    • Connector pinouts
    • Power LED indicator
  • Power setup
    • Installing the PoE (Power over Ethernet)
    • Installing the auxiliary power supply
    • Installing the battery backup, AC fail and low battery
    • Wiring tamper switch
• Chapter 4 DirecDoor Board
  • Introduction
  • Board layout
  • Switches and jumpers
    • Switches
    • Jumpers
  • LED indicators
    • LED indicators on the DirecDoor board
    • Input LED indicators on the DirecDoor board
    • Modem LED indicators on the DirecDoor board
    • UCSIMMPlus board LED indicators on the DirecDoor board
  • Important information for firewall users
  • Configuring upstream communications with the host
    • By network
    • By network with dial fallback
• Chapter 5 Reader Interface
  • Introduction
  • Device addressing
    • Picture Perfect
    • Facility Commander Wnx
  • Setting the DIP switches
  • Setting the jumpers
  • Wiring the readers
  • Wiring the Digital Inputs (DIs)
  • Wiring the door strikes
  • Wiring the Fire Alarm Control Panel (FACP)
• Chapter 6 DO Interface
  • Introduction
  • Device addressing
    • Picture Perfect
    • FCWnx
  • Wiring Digital Outputs (DOs)
• Chapter 7 Testing
  • Testing
• Chapter 8 Controller Firmware Tools
  • Integrated Configuration Tool
    • Requirements
    • Connecting and starting the tool
    • Controller setup overview
    • Controller Configuration menu -> Host/Connection type
    • Controller Information menu -> Controller Information
    • Controller Parameters menu
    • Administration menu
    • Flash controller menu/Flash controller
    • Logging menu
    • Configuration checklist for Integrated Configuration Tool
  • Setting up the DirecDoor controller in the host application
    • Facility Commander Wnx
• Chapter 9 Regulatory Information
  • CE (European) and FCC compliance
  • CE regulatory notice
  • UL compliance
• Chapter 10 Troubleshooting, Maintenance, and Support
  • Troubleshooting
    • Power problems
    • Reader problems
    • Door strike problems
    • DirecDoor problems
    • Diagnostic LED display
  • Maintenance
    • Inserting and removing the UCSIMMPlus board on the DirecDoor board
  • Contacting technical support
• Index