Chip Measurement System Spec Sheet PDF , CMS Specsheet CMSSpec

User Manual: CMSSpecSheet

Open the PDF directly: View PDF PDF.
Page Count: 2

SKC South 800-752-7684 SKC Inc. 800-752-8472 www.skcinc.com
1
CMS
Chip Measurement System
Direct-reading Spot Measurement System
Fast Response — results in 20 seconds
No warm-up required
TWA and action levels reported within 1 to 2 minutes
Highly accurate
Accuracy ± 4 to 7% of measured value for most gases
Consistent flow maintained and corrected for
changes in atmospheric pressure
Measure quantities as low as 0.20 ppm benzene
Not subject to human error and bias
Simple 1, 2, 3 operation
Minimal training required
Concentration displayed on easy-to-read backlit
digital readout in any one of four languages
No calibration gas required
Calibration information is stored on each CMS chip
System integrity assured
Electronic system self-test performed upon start-up
Sampling system test performed before each test
No battery charging
Operates on AA size alkaline batteries
Ready for instant use — ideal for emergency response
Internal data recorder
Stores up to 50 measurements
Data includes time/date, containment/concentration,
and sequential number of measurement series
User may enter measurement location
Recall and display data on demand
Dräger CMS combines substance-specific measuring chips with an electronic-based analyzer for an easy-to-use spot measurement system
that responds quickly and accurately to your sampling needs.
CMS Easy Operation
The CMS Analyzer
The CMS Analyzer is comprised of:
1. A revolutionary optical system
that analyzes color.
2. An integral mass flow controller
and pump system that provide
unparalleled reproducibility.
Bar code
Direction of insert 10 measurement
The CMS Chips
Each CMS Chip contains 10 capillaries
(10 tests) filled with substance-specific
reagent. A barcode on the chip is read
by the analyzer optics to obtain informa-
tion such as gas type, measuring range,
and required measuring time. Gas type,
part number, and batch number are
printed on the chip for user convenience.
Chip calibration remains valid for two
years.
2
Turn on unit by moving the slide
to position 1. Wait for “load chip”
prompt.
Follow instructions on display to
load chip. Move slide to
position 2. Wait for “chip ok.”
Move slide to position 3 to
perform measurement.
1 3
SKC Inc. 800-752-8472 SKC South 800-752-7684 SKC Gulf Coast 800-225-1309 SKC West 800-752-9378
www.skcinc.com
Rev 0606
www.skcinc.com SKC West 800-752-9378 SKC Gulf Coast 800-225-13092
Chip Measuring range (ppm) Cat. No. Price
Acetic acid 2 - 50 802-06330 $ 82.50
Acetone 40 - 600 802-06470 82.50
Ammonia 0.20 - 5.0 802-06550 82.50
Ammonia 2 - 50 802-06130 57.50
Ammonia 10 - 150 802-06020 57.50
Ammonia 100 - 2,000 802-06570 63.00
Benzene‡ 0.2 - 10 802-06030‡ 162.50
Benzene‡ 0.5 - 10 802-06160‡ 162.50
Butadiene 1 - 25 802-06460 82.50
Carbon dioxide 200 - 3,000 802-06190 57.50
Carbon dioxide 1,000 - 25,000 802-06070 55.50
Carbon dioxide 1 - 20 Vol % 802-06210 57.50
Carbon monoxide 5 - 150 802-06080 55.50
Chlorine 0.2 - 10 802-06010 57.50
Ethanol 100 - 2,500 802-06370 82.50
Ethylene oxide 0.4 - 5.0 802-06580 149.50
Formaldehyde 0.2 - 5.0 802-06540 82.50
Hydrochloric acid 1 - 25 802-06090 74.00
Hydrochloric acid 20 - 500 802-06140 74.00
Hydrogen cyanide 2 - 50 802-06100 69.00
Hydrogen peroxide 0.2 - 2.0 802-06440 86.50
Hydrogen sulfide 0.20 - 5.0 802-06520 82.50
Hydrogen sulfide 2 - 50 802-06050 57.50
Hydrogen sulfide 20 - 500 802-06150 57.50
Hydrogen sulfide 100 - 2,500 802-06220 57.50
Isopropanol 40 - 1,000 802-06390 99.00
Mercaptan 0.25 - 6.0 802-06360 99.00
Methanol 20 - 500 802-06380 99.00
Methyl tert Butyl Ether (MTBE)
10 - 200 802-06530 82.50
Methylene chloride 20 - 400 802-06510 82.50
Nitrogen dioxide 0.5 - 25 802-06120 57.50
Nitrous fumes† 0.5 - 15 802-06060† 55.50
Nitrous fumes† 10 - 200 802-06240† 57.50
Oxygen 1 - 25 Vol % 802-06490 102.00
Ozone 25 - 1,000 (ppb) 802-06430 82.50
Perchloroethylene 5 - 150 802-06040 69.00
Petr. hydrocarbons 20 - 500 802-06200 86.50
Petr. hydrocarbons 100 - 3,000 802-06270 82.50
Phosgene 0.05 - 2.0 802-06340 99.00
Phosphine 0.1 - 2.5 802-06400 73.00
Phosphine 1 - 25 802-06410 73.00
Phosphine 20 - 500 802-06420 73.00
Phosphine 200 - 5,000 802-06500 74.00
Propane 100 - 2,000 802-06310 82.50
Styrene 2.0 - 40 802-06560 82.50
Sulfur dioxide 0.4 - 10 802-06110 57.50
Sulfur dioxide 5 - 150 802-06180 69.00
Toluene‡ 10 - 300 802-06250‡ 73.00
Training Chip 802-06290 22.50
Trichloroethylene 5 - 100 802-06320 69.00
Vinyl chloride 0.3 - 10 802-06170 73.00
Vinyl chloride 10 - 250 802-06230 73.00
Water Vapor 0.4 - 10.0 mg/L 802-06450 84.50
Xylene‡ 10 - 300 802-06260‡ 69.00
CMS Chips
Requires refrigerated storage below 50 F (10 C)
†Detects nitric oxide (NO) and nitrogen dioxide (NO
2
) only;
not suitable for nitrous oxide.
CMS Analyzer*
Convenient CMS Kits
CMS is available separately or in
two application-specific kits.
Indoor Air Quality Kit
This kit combines the CMS
analyzer with chips for the most
commonly measured gases and
vapors in indoor air investigations
(carbon monoxide, carbon diox-
ide, formaldehyde, and ozone). It
is an excellent tool for checking
chemical contaminants for this
application. See ordering at left.
Emergency Response Kit
With the alkaline battery-powered
CMS analyzer, remote system,
telescopic probe, and chips for
10 different contaminants con-
tained in this kit, you should be
ready for most emergency
response situations. See ordering
at left.
CMS
Chip Measurement System
Direct-reading Spot Measurement System
Prices subject to change without notice
For all your air sampling needs.
SKC Inc. 800-752-8472 SKC South 800-752-7684 SKC Gulf Coast 800-225-1309 SKC West 800-752-9378
www.skcinc.com
Description Cat. No. Price
CMS Analyzer Set with Data Recorder
includes analyzer, 4 AA alkaline
batteries, and Allen wrench 802-05200 $ 1,729.00
Remote System includes pump,
3-meter extension hose, float-probe,
and screwdriver 802-05060 569.00
Pump/Analyzer Remote System, pump
permanently attached to analyzer 802-17700 2,365.00
Complete Emergency Response Kit
includes analyzer, remote system,
telescopic probe, 10 chips (chlorine,
ammonia, petroleum hydrocarbons,
perchloroethylene, hydrogen sulfide,
nitrous fumes†, carbon dioxide, carbon
monoxide, hydrochloric acid, and
sulfur dioxide) 802-55711 3,585.00
Indoor Air Kit includes analyzer and
four chips (carbon dioxide, carbon
monoxide, ozone, and formaldehyde) 802-56455 2,035.00
Accessories
Leather Carry Case & shoulder strap 802-05080 105.00
Extension Hose includes connector and
float probe, to be used with analyzer/
remote pump 802-17700 only
3 meter Hose 802-17614 107.00
10 meter Hose 802-17613 170.00
Probe Bar with 1-meter Extension Hose,
to be used with analyzer/remote pump
802-17700 only 802-17963 173.00
*
Now available with deep mine approval. Contact your SKC
representative for more information.

Navigation menu