Ha0193T_21_Scanning Galvo System GVSM001 M Manual

• Chapter 1 Safety
  • 1.1 Safety Information
  • 1.2 General Warnings
• Chapter 2 Overview
  • 2.1 Introduction
  • 2.2 System Description
    • 2.2.1 Introduction
    • 2.2.2 The Galvanometer
    • 2.2.3 The Mirror
    • 2.2.4 Servo Driver Board
• Chapter 3 Installation & Initial Set Up
  • 3.1 Dimensions
    • 3.1.1 Motor Assembly Dimensions
    • 3.1.2 Mirror Dimensions
    • 3.1.3 Single Axis Mount Dimensions
    • 3.1.4 XY Mount Dimensions
    • 3.1.5 Heatsink Dimensions
    • 3.1.6 Servo Driver Board Baseplate Dimensions
  • 3.2 Mechanical Installation
    • 3.2.1 Introduction
    • 3.2.2 Fitting The Heatsinks
    • 3.2.3 Typical System Set Up
  • 3.3 Electrical Installation
    • 3.3.1 Choosing A Power Supply
    • 3.3.2 Using the GPS011 Linear Power Supply
    • 3.3.3 Electrical Connections
    • 3.3.4 Diagnostic Signal Descriptions
    • 3.3.5 Setting the Volts/Degree Scaling Factor
• Chapter 4 Operation
  • 4.1 General Operation
  • 4.2 External Enabling of the driver board
  • 4.3 Using a DAQ Card
  • 4.4 Recommended Scanning Angles
• Chapter 5 Troubleshooting
  • 5.1 Common Problems
  • 5.2 Galvanometer Faults
• Appendix A  Specifications and Associated Parts
  • A.1 Specifications
  • A.2 Associated Products
• Appendix B  Calculating the Power Dissipation
  • 2.1 Motor Heatsink
    • 2.1.1 Calculating the Required Thermal Conductivity
• Appendix C  Reasons For Image Distortion
• Appendix D  Regulatory
  • D.1 Declarations Of Conformity
  • D.2 Waste Electrical and Electronic Equipment (WEEE) Directive
  • D.3 CE Certificates
• Appendix E  Thorlabs Worldwide Contacts