14462 6 10 14 GAS CADDY OWNERS MANUAL Handy_GAS_CADDY_OWNERS_MANUAL Handy

User Manual: Handy_GAS_CADDY_OWNERS_MANUAL

Open the PDF directly: View PDF PDF.
Page Count: 2

GC-30 GAS CADDY
INSTRUCTIONS ● PARTS DRAWING ● PARTS LIST
ITEM # 12652
OPERATION
1. This pump is furnished with a hose to transfer fuel.
2. Rotate pump handle briskly to obtain initial prime.
3. Rotate pump handle clockwise to draw from the caddy - counterclockwise rotation for suction.
HANDY, DIVISION OF JANCO INDUSTRIES,INC.
401 South 2nd. Marshalltown, IA 50158 Ph: 855-752-5446 Fax 641-752-1205 www.handyindustries.com
Note: Decals included to label
contents of caddy. Cut and apply.
NOTE: The arrow which is on base plate inside gauge, must point to opposite corner of gas caddy.
This is necessary to prevent gauge float arm from binding against tank sides.
ASSEMBLY
1. Remove all packaging and check carefully
for concealed shipping damage.
2. Take the handle arm and place on pump with slot end
on pump shaft. The use supplied nut and tighten secure
ly. Take the black handle and bolt, and thread into handle
and arm far enough that there is thread sticking through
the backside and use supplied nut on backside of handle
arm to lock black handle in place. Remove the red plugs
from pump and insert steel hex bushing into bottom side of
pump. Be sure to apply teflon tape to the threads of hex
bushing.
3. Slide wheels onto axle and snap on the retaining rings.
4. Install pump and hose. Refer to parts illustration.
5. If desired, mount caddy identification label (Unleaded,
Gasoline, Diesel or Mixed Fuels) on front or side of caddy.
6. Always have ground wire clamp attached to a known
ground.
10409
10366
10337
GAUGE ASSEMBLY & VENT DOME DETAIL
10409 GAUGE REPAIR KIT (GAUGE ONLY)
10366 GAUGE ASSEMBLY
10337 DOME (NOT INCLUDED IN GAUGE ASSEMBLY KIT)
GC-30 GAS CADDY
PARTS LIST
10416 5 - PACK DECALS FOR TANK
HANDY LIMITED WARRANTY
Handy,Division of Janco Industries,Inc. warrants to the original purchaser of this product, all parts to be free
from defects in manufacture for a period of one (1) year from date of delivery. Notice of a defective part must
be received in writing at Handy Industries within one (1) year of purchase.All defective parts must be
returned to Handy Industries and which, upon our examination any parts which are defective in manufacture
or workmanship,will be replaced or put in good operating condition. This warranty does not apply to dam-
age resulting from accident, improper installation, repair,operation or maintenance,negligence or neglect.
THE COST OF SUCH REPLACEMENT OR REPAIR SHALL BE EXCLUSIVE REMEDY FOR ANY BREACH OF ANY WARRAN-
TY AND HANDY JANCO DIVISION SHALL NOT BE LIABLE TO ANY PERSON FOR CONSEQUENTIAL DAMAGE, OR
INJURY, OR COMMERCIAL LOSS RESULTING FROM ANY BREACH OF WARRANTY.HANDY DIV. JANCO INDUSTRIES
MAKES NO WARRANTY OR MERCHANTABILITY,MAKES NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE
AND MAKES NO OTHER WARRANTY EXPRESSED OR IMPLIED,INCLUDING IMPLIED WARRANTY ARISING FROM THE
COURSE OR DEALING OR USAGE OF THE TRADE.
6-10-14 14462

Navigation menu