SCP 01 Instructions SCP01

SCP01-2 SCP01-2

SCP01-1 SCP01-1

User Manual: SCP01

Open the PDF directly: View PDF .
Page Count: 2

The Snap Circuits Kit uses electronic blocks that snap onto a clear plastic base grid to build

different circuits. These blocks have different colors and numbers on them so that you can

easily identify them.

Build the circuit shown by placing all the parts with a black 1next to them

on the clear plastic base grid first. Then, assemble parts marked with a 2, and finally parts

marked with a 3. Install three (3) “AA” batteries (not included) into the battery holder (B3).

Turn on the slide switch (S1), you hear a beep signaling that you may begin recording. Talk

into the microphone (X1) up to 8 seconds, and then turn off the switch (it also beeps after the

8 seconds expire).

Press the press switch (S2) for playback. It plays the recording you made followed by one of

three songs.If you press the press switch before the song is over, the music will stop. You may

press the press switch several times to play all three songs.

You can erase the recording you made by removing the

microphone (X1) from project #1. Turn on the slide switch

(S1), you hear a beep signaling that the IC begins recording,

then turn it off. The previous recording is now erased. Press

the press switch (S2) for playback and there should be no

recording before the music starts.

If you have any problems, contact Elenco®

Copyright © 2005 Elenco®Electronics, Inc. All Rights Reserved. • 150 Carpenter Ave. • Wheeling, IL 60090

(800) 533-2441 Fax: (847) 520-0085 • e-mail: elenco@elenco.com • Web site: www.elenco.com or www.snapcircuits.net

PPrroojjeecctt ##11 MMuussiiccaall RReeccoorrddeerr

PPrroojjeecctt ##22

Eraser

Modify the circuit shown by removing the microphone (X1)

and the slide switch (S1). Press the press switch (S2) to

start the first song. When the music stops, press the press

switch again to hear the second song. When the second

song stops, press the press switch again to hear the third

song. If you press the press switch before the song is over

the music will stop.

PPrroojjeecctt ##33

Playing Music

Modify the circuit in project #3 by replacing the 3-snap

across points A & B with the microphone (X1). Press the

press switch (S2) for playback and the music is not as loud.

PPrroojjeecctt ##44

Loudness Control

WARNING: SHOCK HAZARD -

Never connect Snap Circuits

to the electrical outlets in your

home in any way!

WARNING: Always check your wiring before

turning on a circuit. Never leave a circuit

unattended while the batteries are installed.

Never connect additional batteries or any other

power sources to your circuits. Musical Recorder

Model SCP-01

Note

753140

BATTERIES:

Use only 1.5V AA type (not included).

Insert batteries with correct polarity.

Non-rechargeable batteries should not

be recharged. Rechargeable batteries

should only be charged under adult

supervision, and should not be

recharged while in the product. Do not

mix alkaline,standard (carbon-zinc), or

rechargeable (nickel-cadmium)

batteries. Remove batteries when they

are used up. Do not short circuit the

battery terminals. Never throw batteries

in a fire or attempt to open its outer

casing. Batteries are harmful if

swallowed, so keep away from small

children.

Important: If any parts are missing or

damaged, DO NOT RETURN TO RETAILER.

Call toll-free (800) 533-2441 or e-mail us at:

help@elenco.com.

Customer Service • 150 Carpenter Ave. •

Wheeling, IL 60090 U.S.A.

You may order additional / replacement parts

at our web site: www.snapcircuits.net

Qty. ID Name Part #

r1 Base grid 6SCBGM

r3 1 1-snap wire 6SC01

r5 2 2-snap wire 6SC02

r3 3 3-snap wire 6SC03

r1 6 6-snap wire 6SC06

r1 D3 Diode 6SCD3

r1 B3 Battery holder 6SCB3

r1 Q2 NPN transistor 6SCQ1

r1 S1 Slide switch 6SCS1

r1 S2 Press switch 6SCS2

r1 SP Speaker 6SCSP

r1 U6 Recording IC 6SCU6

r1 X1 Microphone 6SCX1

OTHER SNAP CIRCUITS PRODUCTS!

FM Radio

Model SCP-02

Motion Detector

Model SCP-03

Music Box

Model SCP-04

Space Battle

Model SCP-05

Flying Saucer

Model SCP-06

PARTS LIST

Contact Elenco®to find out where you can purchase these products.

Snap Circuits Jr. Model SC-100

Build over 100 projects, contains over 30 parts.

Snap Circuits Model SC-300

Build over 300 projects, contains over 60 parts.

Snap Circuits Pro Model SC-500

Build over 500 projects, contains over 75 parts.

Snap Circuits Extreme Model SC-750

Build over 750 projects, contains over 80 parts, and PC interface included.