SFD OlderCodes.vp Older Codes

• Table of Contents
  • CHAPTER I Introduction 1
    • Overview 1
    • Organization 3
    • Recommended Reading 4
  • CHAPTER II Design Algorithms 5
    • Design Load Combinations 6
    • Design and Check Stations 8
    • P- Effects 8
    • Element Unsupported Lengths 9
    • Effective Length Factor (K) 11
    • Choice of Input Units 14
  • CHAPTER III Check/Design for AISC-ASD01 15
    • Design Loading Combinations 18
    • Classification of Sections 22
    • Special Seismic Provisions of Member Design 24
      • Ordinary Moment Frames (OMF) 24
      • Intermediate Moment Frames (IMF) 25
      • Special Moment Frames (SMF) 25
      • Ordinary Concentrically Braced Frames (OCBF) 28
      • Special Concentrically Braced Frames (SCBF) 28
      • Eccentrically Braced Frames (EBF) 29
    • Calculation of Stresses 32
    • Calculation of Allowable Stresses 33
      • Allowable Stress in Tension 33
      • Allowable Stress in Compression 34
        • Flexural Buckling 34
        • Flexural-Torsional Buckling 36
      • Allowable Stress in Bending 38
        • I-sections 38
        • Channel sections 42
        • T-sections and Double angles 43
        • Box Sections and Rectangular Tubes 43
        • Pipe Sections 44
        • Round Bars 45
        • Rectangular and Square Bars 45
        • Single-Angle Sections 45
        • General Sections 48
      • Allowable Stress in Shear 48
    • Calculation of Stress Ratios 49
      • Axial and Bending Stresses 49
      • Shear Stresses 51
    • Joint Design 52
      • Design of Continuity Plates 52
      • Design of Doubler Plates 56
      • Weak Beam Strong Column Measure 59
      • Evaluation of Beam Connection Shears 61
      • Evaluation of Brace Connection Forces 63
  • CHAPTER IV Check/Design for AISC-ASD89 65
    • Design Loading Combinations 68
    • Classification of Sections 68
    • Calculation of Stresses 72
    • Calculation of Allowable Stresses 73
      • Allowable Stress in Tension 73
      • Allowable Stress in Compression 73
        • Flexural Buckling 73
        • Flexural-Torsional Buckling 75
      • Allowable Stress in Bending 80
        • I-sections 80
        • Channel sections 83
        • T-sections and Double angles 84
        • Box Sections and Rectangular Tubes 85
        • Pipe Sections 86
        • Round Bars 86
        • Rectangular and Square Bars 86
        • Single-Angle Sections 87
        • General Sections 89
      • Allowable Stress in Shear 89
    • Calculation of Stress Ratios 91
      • Axial and Bending Stresses 91
      • Shear Stresses 93
  • CHAPTER XIII Design Output 94
    • Overview 311
    • Graphical Display of Design Output 312
    • Tabular Display of Design Output 313
    • Member Specific Information 314
      • References 317
        • Index 319