SPEEDFIT END Instructions

User Manual:

Open the PDF directly: View PDF PDF.
Page Count: 2

™
The w
orld’s best-selling electric floor heating brand
WARMUP INC.
USA: us@warmup.com
Tel.: 1-888-927-6333
www.warmup.com
CANADA: ca@warmup.com
Tel.: 1-888-592-7687
www.warmup.ca
END-KIT
INSTALLATION INSTRUCTIONS ™
The w
orld’s best-selling electric floor heating brand
END-KIT
INSTALLATION INSTRUCTIONS
DESCRIPTION
The Warmup End-Kit is a solid termination kit for NAMSR self-
regulating cables.
APPLICATION
Used on both Roof & Gutter and for Pipe-Freeze Protection
applications, the End-Kit provides the installer with a solid,
mechanical cable termination. It saves time and materials over
traditional heat-shrinking techniques. These connection kits
must be installed according to NAMSR guidelines and minimum
installation temperatures.
REQUIRED TOOLS
• Wire cutter
• Nose pliers
• Screwdriver
• Tie Wrap
APPROVALS KIT CONTENT
Item Qty Description
A 1 Seal Plate for Main box
B 1 Main End Seal Box
C 1 (colour) Grommets
D 1 Label
The components are electrical devices. They must be installed
correctly to ensure proper operation and to prevent shock or fire.
Carefully follow all of the installation instructions and read these
important warnings.
• To minimize the danger of fire from sustained electrical arcing
if the heating cable is damaged or improperly installed, and
to comply with the requirements of the national electrical
codes, ground-fault equipment protection must be used on
each heating cable branch circuit. Arcing may not be stopped by
conventional circuit protection.
• Bus wires will short if they contact each other. Keep bus
wire separated.
• Keep ends of heating cable and kit components dry before and
during installation.
• The black heating cable core is conductive and can short. It must
be properly insulated and kept dry.
• Component approvals and performance are based on the use
of specified parts only. Do not substituted parts or use
vinyl electrical tape.
• Leave these installation instructions with the user for future
reference.
• The heating cable should not be embedded in the thermal
insulation.
• The cable should not be twisted during installation.
• De-energize all power circuits before installation or servicing.
• The conductive layer of this heating cable device must be
connected to a suitable grounding/earthing terminal.
WARNING
™
The w
orld’s best-selling electric floor heating brand
WARMUP INC.
USA: us@warmup.com
Tel.: 1-888-927-6333
www.warmup.com
CANADA: ca@warmup.com
Tel.: 1-888-592-7687
www.warmup.ca
™
The w
orld’s best-selling electric floor heating brand
END-KIT
INSTALLATION INSTRUCTIONS
Outer jacket
Copper Braid
Outer jacket
Insulation
PTC Cores
Bus wires
Cable with outer jacket for dry and wet conditions
INSTALLATION INSTRUCTIONS
1- Insert first the Pressure Seal End then the Grommet
into the cable.
2-
• Do not cut the braiding.
• Strip outer jacket.
• Slightly bend the cable where you made the cut to
strip it.
3- Remove excess braiding.
4-
• Insert the heating cable into the main box.
• Install the grommet into position.
• Screw the Pressure Seal End into the main box.
5-
• Affix the Low Profile End Seal Box and side wires to
the pipe with tape.
• Install insulation.
• Install label on the top of the insulation protector.
• Give instructions to the owner/user.

Navigation menu