WaveDump UM2091 Wave Dump User Manual Rev13

• Purpose of this Manual
• Change Document Record
• Symbols, Abbreviated Terms and Notation
• Reference Document
• Index
• List of Figures
• List of Tables
• 1 Introduction
• 2 Software Interface
  • Overview
  • Block Diagram
  • Drivers & Libraries
    • Drivers
    • Libraries
  • Installation
• 3 On-line Commands
• 4 Configuration File Syntax
  • Common Settings
    • OPEN LinkType LinkNumber NodeNumber BaseAddress
    • CORRECTION_LEVEL <CORR_MASK> <CUST_TABLE_MASK> <FILENAME1> <FILENAME2> ...
    • DRS4_FREQUENCY option
    • GNUPLOT_PATH “path”
    • OUTPUT_FILE_FORMAT option
    • OUTPUT_FILE_HEADER option
    • RECORD_LENGHT Ns
    • TEST_PATTERN option
    • ENABLE_DES_MODE option
    • EXTERNAL_TRIGGER option
    • FAST_TRIGGER option
    • ENABLED_FAST_TRIGGER_DIGITIZING option
    • MAX_NUM_EVENTS_BLT Ne
    • DECIMATION_FACTOR Ns
    • POST_TRIGGER value
    • PULSE_POLARITY option
    • USE_INTERRUPT value
    • FPIO_LEVEL option
    • WRITE_REGISTER address data mask
    • SKIP_STARTUP_CALIBRATION option
  • Individual Settings
    • ENABLE_INPUT option
    • BASELINE_SHIFT value
    • DC_OFFSET value
    • GRP_CH_DC_OFFSET dc_0, dc_1, dc_2, dc_3, dc_4, dc_5, dc_6, dc_7
    • TRIGGER_THRESHOLD value
    • CHANNEL_TRIGGER option
    • GROUP_TRG_ENABLE_MASK mask
  • Individual Settings for x742 Fast Trigger Channels
    • DC_OFFSET value
    • TRIGGER_THRESHOLD value
• 5 Temperature Protection (725 and 730 series only)
• 6 Channel Calibration (725, 730, 751 and 761 series only)
  • Channel Calibration Procedure
• 7 Technical Support