Z Stack User's Guide CC2530 ZNP For Zig Bee PRO Network Processor Sample Applications
User Manual:
Open the PDF directly: View PDF
Page Count: 74
- Abbreviations
- 1. Introduction
- 2. Assumptions
- 3. CC2530 ZNP Software and Hardware Description
- 2.1. Development System Requirements
- 2.2. CC2530 ZNP Software
- 2.3. CC2530 ZNP Hardware
- 2.3.1. MSP430 based hardware setup used for the sample applications
- 2.3.2. Hardware setup for a USB connected ZNP
- 2.3.3. Hardware for programming the CC2530EM
- 2.3.4. Hardware for programming the CC2531USBDongle
- 2.3.5. Easiest and quickest hardware choice
- 3. Building the ZNP needed for the sample application
- 4. Configuring and Using Z-Stack ZAP sample applications
- 4.1. ZAP Sample Applications Setup (general)
- 4.1.1. Hardware
- 4.1.2. Software
- 4.2. Temperature Voltage Sensor Application (TVSA)
- 4.2.1. Hardware and Software setup
- 4.2.2. Available Settings
- 4.2.3. UART Connection
- 4.2.4. Running the example
- 4.2.5. In Depth on the Example
- 4.3. Home Automation (HA) Sample Application
- 4.3.1. Hardware and Software setup
- 4.3.2. Running the example
- 4.3.3. In Depth on the Example
- 4.4. Smart Energy Sample Application
- 4.4.1. Required Tools
- 4.4.2. Configuring Certicom Keys for Production Devices
- 4.4.3. Getting Started
- 4.4.4. Theory of Operation
- 4.4.5. ESP
- 4.4.6. Simple Metering Device
- 4.4.7. Load Control Device
- 4.4.8. PCT
- 4.4.9. In Premise Display
- 4.4.10. Range Extender
- 4.4.11. Limitations of the SE Sample Application
- 4.5. ZAP Proxy to ZNP SBL
- 4.5.1. Hardware and Software setup
- 4.5.2. Required Settings
- 4.5.3. UART Connection
- 4.5.4. Incorporating the example
- 4.5.5. In Depth on the Example
- FAQ
- 5. References