Citrex H4 Manual EN
User Manual:
Open the PDF directly: View PDF
Page Count: 52
- Figure 1: Power supply
- Figure 2: Flow channel
- Figure 3: Differential pressure connector
- Figure 4: High-pressure connector
- Figure 5: Oxygen sensor holder
- Figure 6: Protective cap
- Figure 7: Screwing in the oxygen sensor
- Figure 8: Oxygen sensor cable
- Figure 9: Electrical interfaces
- Figure 10: Replacing the battery
- Figure 11: User controls
- Figure 12: Info display
- Figure 13: Battery indicator
- Figure 14: Ethernet interface
- Figure 15: Trigger
- Figure 16: Gas standard
- Figure 17: Gas type
- Figure 18: Gas humidity
- Figure 19: Setting the X-axis
- Figure 20: O2 calibration
- Figure 21: Profiles
- Figure 22: Numerical readings
- Figure 23: Measurement curves
- Figure 24: Zero calibration
- Figure 25: Screen displays "Calibration Air"
- Figure 26: Screen displays "Calibration Oxygen and Air"
- Figure 27: General measurement setup
- Figure 28: Bad setup
- Figure 29: Measurement setup for checking ventilators
- Figure 30: Measurement setup for gases at high pressure
- Figure 31: Profile editor in Internet Explorer
- Figure 32: Profile editor "configuration"
- Figure 33: Monitoring numerics
- Figure 34: Monitoring panels
- Figure 35: Interface definition
- Figure 36: Trigger
- Figure 37: Delay
- 1 Introduction
- 2 Intended use
- 3 Safety instructions
- 4 Symbol explanation
- 5 Start-up
- 6 Operation
- 7 Calibration
- 8 Connecting the device
- 9 Profile editor
- 10 Configuration tool
- 11 Reading measurement data
- 12 Servicing and care
- 13 Accessories and spare parts
- 14 Disposal
- 15 Directives and approvals
- 16 Specifications
- 17 Appendix