Mechanical Instructions

User Manual:

Open the PDF directly: View PDF PDF.
Page Count: 22

Scroll down to view the document on your mobile browser.
  0.5000 inch dia“SPRING HOLE”(SPRING HOLE is also used to access the robot’s power switch)† Drill with #25 bit (0.1495 inch dia)††††0.62149.427010.00003.21862.5000 TYP1.50002.21754.98616.0000(Top View; Rear Edge of Board)Board = any 0.1250 to 0.5000 inch thick material of strength similar to plexiglassAll dimensions are in inches ±0.00012016 © International Aerial Robotics Competition5.0000ROBOT TOP PLATEHalf of the target robots will have the top plate painted with Krylon "Gloss Emerald Green #52016” (RGB = 22, 86, 16) and the other half Krylon “Gloss Banner Red #52108” (RGB = 176, 22, 4).  Obstacle robots top plates will be white.0.400000.40000“TOP TOUCH”SWITCH NOTCHArduino POWERSWITCH NOTCH1.333002.000001.000002.50000Counter sink hole to a depth of 0.0600 incheson the bottom side of the board.Glue a 3/4 inch dia washer witha 7/16 inch center hole into thecountersunk area as a spring stop.0.7500 in diaSpring stop

Navigation menu