Dongguan Longjing Electronic LJ-001 Bluetooth earphone User Manual
Dongguan Longjing Electronic Co., Ltd Bluetooth earphone Users Manual
Users Manual
SIZE: 85X112 mm
Pairing and Connection:
1: The distance between the smartphone and the headset should be 30 feet.
2: Press and hold the key for about 5 seconds and release it when the red and blue
LEDs alternate. At this point the headset has entered the pairing mode.
3: Enable the Bluetooth function on the smartphone & search for a new connection.
Select "Wireless Earbuds" to pair. After the connection is successful the
4: blue LED of the headset will blink slowly.
5: Volume Up, Volume Down,
6: Universal Switch Telephone Answering key
Headphone 10mm
/Sensitivity: 96dB±3dB(at 1KHz 0.5vRMS)
/Impedance: 16Ω
/Frequency Response: 20-20000hz
/Cord Length: ≤70CM
Microphone
/Dimensions: 4*1.5MM
/Sensitivity: -42dB+/-3dB
/Frequency Response: 30-16000HZ
/Directivity: Omnidirectional
FCC ID:2ANPN-LJ-001
FCC RF Exposure Information and Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
LJ-001, LJ-002
This equipment generate, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
·Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver.
·Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.