Drive Medical Design Mobility Aid 11120Kd 1 Users Manual

11120kd-1 to the manual daf8ccbc-ed81-4ef7-b24f-84480d8435ae

: Drive-Medical-Design Drive-Medical-Design-Drive-Medical-Design-Mobility-Aid-11120Kd-1-Users-Manual-514800 drive-medical-design-drive-medical-design-mobility-aid-11120kd-1-users-manual-514800 drive-medical-design pdf

Open the PDF directly: View PDF .
Page Count: 2

wheeled, drop arm

commode

item 11120KD-1

www.drivemedical.com

lifetime limited

warranty

Your Drive brand product is warranted to be free

of defects in materials and workmanship for the

lifetime of the original consumer purchaser.

This device was built to exacting standards and

carefully inspected prior to shipment. This Lifetime

Limited Warranty is an expression of our confi-

dence in the materials and workmanship of our

products and our assurance to the consumer of

years of dependable service.

In the event of a defect covered by this

warranty, we will, at our option, repair or replace

the device.

This warranty does not cover device failure

due to owner misuse or negligence, or normal

wear and tear. The warranty does not extend to

non-durable components, such as rubber

accessories, casters, and grips, which are subject

to normal wear and need periodic replacement.

If you have a question about your Drive device or

this warranty, please contact an authorized Drive

dealer.

© 2006 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

1. Remove contents from box.

2. Attach front cross brace to top of wheeled leg

section by depressing push button and sliding into

place. A snap will be heard when cross brace is in

place. Repeat for back cross brace.

3. Attach second wheeled leg section to cross braces.

4. Insert back support and arm section into frame.

Tighten knobs.

5. To drop arm, depress release button on arm and

gently allow to drop until reaching arm stop.

6. Attach lower frame support and tighten knob.

7. Attach footrests to front of frame using nuts and

bolts provided.

8. Install commode bucket by placing it in grooves in

bucket frame.

9. Align the toilet seat clamps onto the back frame rail.

(Both clamps should sit outside the pail brackets).

Push down on seat until clamps snap firmly

into place.

10. When removing the seat grasp the back of the seat

and lift.

1. Toilet seat must be in down position before use. Failure

to do so may result in breakage of commode and

possible injury.

2. Do NOT install commode without first reading and

understanding this assembly and instruction sheet. If

you can not understand these instructions, contact a

healthcare dealer or technical professional before

attempting to install. Otherwise, injury or damage

may occur.

3. Inspect all parts for shipping damage before assembly.

If there is shipping damage - DO NOT USE.

Contact dealer/carrier for further instructions.

4. Ensure ALL screws, nuts and/or bolts are tightened.

5. Users with limited physical strength should be supervised

or assisted while using commode.

FIGURE 1

Bucket

Frame

Back

Support

Release

Button

Arm

Bucket

commode assembly

instructions and precautions

assembling commode

additional precautions

Lower Frame

Support

Footrests