Dynabook SD00UBT Bluetooth SD Card User Manual RF Exposure statement
Toshiba Corporation Bluetooth SD Card RF Exposure statement
Dynabook >
Contents
- 1. Product Specification
- 2. RF exposure language and compliance statement
RF exposure language and compliance statement
Confidential
Bluetooth™ SD CARD
RF exposure / environment evaluation Rev.1.0 (April 23, 2001) 1
Bluetooth™ SD CARD
RF exposure / environmental evalutation
Rev. 1.0 (April 23, 2001)
TOSHIBA CORPORATION
Digital Media Network Company
Confidential
Bluetooth™ SD CARD
RF exposure / environment evaluation Rev.1.0 (April 23, 2001) 2
Revision History
Revision Date Comments
1.0 2001-04-23 Initial Revision
Confidential
Bluetooth™ SD CARD
RF exposure / environment evaluation Rev.1.0 (April 23, 2001) 3
USA-Federal Communications Commission(FCC)
This device complies with Part 15 of FCC Rules. Operation of the devices in a
Bluetooth System is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may cause undesired operation.
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of the Toshiba Bluetooth™ SD Card is far below the
FCC radio frequency exposure limits. Nevertheless, the Toshiba Bluetooth™ SD
Card shall be used in such a manner that the potential for human contact during
normal operation is minimized. When using this device , a certain separation
distance between antenna and nearby persons has to be kept to ensure RF
exposure compliance. The distance between the antennas and the user should not
be less than 5.0cm.
Refer to the Regulatory Statements as identified in the documentation that comes
with those products for additional information.
The Toshiba Bluetooth™ SD Card is far below the FCC radio frequency exposure
limits.
Nevertheless, it is advised to use the Toshiba Bluetooth™ SD Card in such a
manner that human contact during normal operation is minimized.
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try and correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Toshiba is not responsible for any radio or television interference caused by
unauthorized modification of the devices included with this Toshiba Bluetooth™
SD Card, or the substitution or attachment of connecting cables and equipment
other than specified by Toshiba .
The correction of interference caused by such unauthorized modification,
substitution or attachment will be the responsibility of the user.