Dynabook UPA3745WL Wireless Laser Mouse User Manual

Toshiba Corporation Wireless Laser Mouse

User Manual

Safety Notice 1 This product complies with IEC 60825-1, class 1 laser product. 2 Your product complies with FCC and CE rules. 3 This product has no serviceable parts. Use of controls or adjustments of procedures other than the user guide may result in danger. Nano Receiver Wireless Laser Mouse USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation Please DO NOT direct the laser beam at anyone’s eye.
1Federal Communication Commission Interference Statement FCC Caution: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
2 Functional Introduction Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Pull AAA Battery 1’st 2’nd Nano ReceiverScrolling Wheel & Low Battery / Pairing indicator Left button Connect Button Right button Battery Cover
3 Nano Receiver Setup the Connection between the Receiver and the Mouse 1. Plug the Nano receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pairing mode. 4. Pairing: Re-plug the Nano receiver into the USB port of your computer. If the mouse does not work after 10 seconds, then press the connect buttons on the mouse again. (Nano receiver has auto pairing Take out Push
4function). 5.The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. The mouse remains off afterwards. 6. When the battery is low, the Low Power indicator blinking. During pairing Green LED Blinking 10 Sec. Connected NG Green LED Off Red LED Blinking Low Battery Red LED on 10 Sec. Power On Scrolling Wheel & Low Battery / Pairing indicator Connected OK

Navigation menu